Vari Lite VL800 PROPAR User manual

VL800 PROPAR
QUICK START GUIDE

2
QUICK START GUIDE
912400575012QSG WWW.VARI-LITE.COM
INTRODUCTION
1. ABOUT THIS MANUAL
The document provides basic installation and operation instructions for the following product(s):
• VL800 PROPAR
Read all instructions before installing or using this product. Retain this manual for future reference.
Additional product information and descriptions may be found on the datasheet and user manual. Both are
available for download on our website at www.vari-lite.com.
2. INCLUDED ITEMS
Each VL800 PROPAR luminaire includes the following items:
• VL800 PROPAR
• Quick Start Guide
3. SAFETY NOTICES
• Unpack and check carefully for damage from shipping before using the unit.
• Do install and operate by operator.
• Use safety tether when mounting.
• Install only in locations with adequate ventilation of at least 50cm clearance from adjacent surfaces.
• Ensure sure that ventilation slots are not blocked to prevent overheating.
• Before operating, ensure that the voltage and frequency of power supply match the power requirements
of the unit.
• It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
• Maximum ambient temperature TA: 40°C minimum ambient temperature TA : 0. Don’t operate it where
the temperature is higher than this.
• Don’t connect the device to any dimmer pack.
• First run, there will be smoke or smells, and all disappearing a few minutes later.
• Make sure there are no flammable materials close to the unit while operating, as it is fire hazard.
• Look over power wires carefully, replace immediately if there is any damage.
• When in use, fixture surface temperature may reach up to 65°C. DO NOT touch the housing.
• Never run on for a long time lest shortening lifespan.
• Do not operate in dirty and dusty environment, also cleaning fixtures regularly.
• Do not allow children to operate the fixture.
• Do not touch any wire during operation as there might be a hazard of electric shock.
• Avoid power wires together arounding other cables.
• In the event of serious operating problem, stop using the unit immediately.
• Never turn on and o the unit time after time.
• The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.
• Do not open the unit as there are no user serviceable parts inside. Never try to repair the unit by yourself.
Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest
authorized technical assistance center.
• Disconnect the mains power if the fixture is not used for a long time.
• Do use original packing materials once transport it again.
• To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.
• Do not look directly at the LED light beam while the fixture is on.
• To protect the machine, power o 10s rear can electrify.

3
QUICK START GUIDE
912400575012QSG WWW.VARI-LITE.COM
MOUNTING
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and is able to support a weight of 10 times of the unit’s weight. Also always use a safety cable that
can hold 12 times of the weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out of the touch of peo-
ple and has no one pass by or under it.
CONTROL PANEL
QUICK REFERENCE DMX MAPS
TABLE 1. 16-BIT CHANNEL MODE
CHANNEL PARAMETER
1 Intensity high
2 Intensity low
3 Zoom
4 Red high
5 Red low
6 Green high
7 Green low
8 Blue high
9 Blue low
10 White high
11 White low
12 Color preset
13 Strobe speed
14 Strobe speed
15 Control channel
1 LCD display - shows the menu and selected functions
2 Buttons:
MENU - To select the programming functions
DOWN - To go backward in the selected functions
UP - To go forward in the selected functions
ENTER - To confirm the selected functions
5
6
7
12
3
4
3 DMX IN - 5-pin XLR cable to link DMX console
4 DMX OUT - 5-pin XLR cable to link to the next unit
5 Fuse T5A - protects the unit from damage due to over current
6 Power In - connacts to power supply
7 Power Out - connects to next fixture

4
QUICK START GUIDE
912400575012QSG WWW.VARI-LITE.COM
TABLE 2. 8-BIT CHANNEL MODE
CHANNEL PARAMETER
1 Intensity
2 Zoom
3Red
4 Green
5 Blue
6 White
7 Color preset
8 Strobe speed
9 Strobe speed
10 Control channel
TABLE 3. 8-BIT COLOR MODE
CHANNEL PARAMETER
1 Zoom
2Red
3 Green
4 Blue
5 White

5
QUICK START GUIDE
912400575012QSG WWW.VARI-LITE.COM
IMPORTANT INFORMATION
WARNINGS AND NOTICES
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
• For indoor, dry locations use only. Do not use outdoors.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tamper-
ing by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Not for residential use. Do not use this equipment for other than intended use.
• Refer service to qualified personnel.
SAVE THESE INSTRUCTIONS.
WARNING: You must have access to a main circuit breaker or other power disconnect device before installing
any wiring. Be sure that power is disconnected by removing fuses or turning the main circuit breaker o before
installation. Installing the device with power on may expose you to dangerous voltages and damage the device.
A qualified electrician must perform this installation.
WARNING: Refer to National Electrical Code® and local codes for cable specifications. Failure to use proper
cable can result in damage to equipment or danger to personnel.
WARNING: This equipment is intended for installation in accordance with the National Electric Code® and
local regulations. It is also intended for installation in indoor applications only. Before any electrical work is
performed, disconnect power at the circuit breaker or remove the fuse to avoid shock or damage to the control.
It is recommended that a qualified electrician perform this installation.
CUSTOMER SERVICE
If you have any questions regarding this product, please contact Customer Service at [phone] or via
e-mail at entertainment.service@signify.
LIMITED 2-YEAR WARRANTY
Vari-Lite oers a two-year limited warranty on its control products against defects in materials or workmanship
from the date of delivery. A copy of Vari-Lite two-year limited warranty containing specific terms and conditions
can be obtained from the Vari-Lite website at www.vari-lite.com or by contacting your local Vari-Lite oce.
2000851

AMERICAS
10911 Petal Street
Dallas, TX 75235
Tel: [phone]
Fax: [phone]
ASIA
Unit C, 14/F, Roxy Industry Centre
41-49 Kwai Cheong Road
Kwai Chung, Kwai Tsing
Hong Kong
Tel: [phone]
Fax: [phone]
Room 1201, Freetown Tower D
E 3rd Ring Rd S, 58
Chaoyang Qu
Beijing Shi, China
Tel: [phone]
Fax: [phone]
B-1-27, Dataran Cascades, No. 13A
Jalan PJU 5/1
Kota Damansara PJU 5
47810 Petaling Jaya
Selangor, Malaysia
Tel: [phone]
Fax: [phone]
EUROPE
Rondweg Zuid 85
Winterswijk 7102 JD
Netherlands
Tel: [phone]
Fax: [phone]
24 Sovereign Park
Coronation Road
Park Royal, London
NW10 7QP
United Kingdom
Tel: [phone]
OCEANIA
14H Vega Place
Rosedale
Auckland 0632
New Zealand
Tel: [phone]
VL800 PROPAR Quick Start Guide
Document no.: 912400575012QSG
Version date: August 15 2019
© 2019 Signify Holding. All rights reserved.
All trademarks are owned by Signify Holding or their respective owners. The information pro-
vided herein is subject to change, without notice. Signify does not give any representation or
warranty as to the accuracy or completeness of the information included herein and shall not
be liable for any action in reliance thereon. The information presented in this document is not
intended as any commercial oer and does not form part of any quotation or contract, unless
otherwise agreed by Signify. Data subject to change.