Vari Lite Band-It Extra Small User manual

PN 30-123 Rev 10/03
Ban
d
-I
t
™Fittin
g
Instructions
This document contains important information that must be passed on to
the user of the product. Do not discard this document before delivery to the
end user.
An ankle-positioning device does more than lower extremity positioning. Ankle-positioning enhances
full body positioning. It is ideal for individuals with poor lower extremity control, spasticity, impaired
sensation, eversion/inversion malalignments, body-scheme deficits, and heel cord shortening. Ankle-
positioning devices are designed to be worn over socks and shoes.
Each VARILITE Band-It mounts to the footplate of a wheelchair by two Dual Tab Tri-Ends, secured by 16/20
in. screws.
Fitting
Size Selection
The Band-it is designed to secure around the ankle, with the body of the
device extending over the top of the client’s shoes to distribute pressure
over a larger area. It is important that a client wear shoes and socks
during Band-it use. Measure the circumference of the ankle, two finger
widths above the malleoli (Fig. 1). When measuring, the client should be
wearing shoes, socks and applicable orthoses.
Extra Small…………….4½ – 6 in. (12-23cm)
Small………………………6 – 9 in. (15-23cm)
Medium…………………...9 – 11 in. (23-28cm)
Large……………………..11 – 13 in (28-33cm)
Installation
1. Fasten Band-It
Align accent webbing with Achilles’ tendon
and fasten buckle (Fig. 2). Buckle will not be
centered. Adjust webbing using D-ring. Band-
It should be snug, but not constricting (Fig. 3).
2. Adjust Dynamic Strap component
For a static effect, pull the webbing on the
topside of the tension lock. This eliminates the
dynamic component (Fig. 4). To make use of
the dynamic component, decrease the tension
of the webbing (Fig. 5)
Note: The use of dynamic positioning should
be based on the client’s needs, desired
positioning effect and therapist’s
recommendations.
Fig. 1
Fig. 2 Fig. 3
Fig.
4
Fig. 5

PN30-123 Rev 10/03
Ban
d
-I
t
™Fittin
g
Instructions
This document contains important information that must be passed on to
the user of the product. Do not discard this document before delivery to the
end user.
This document contains
important information that
must be passed on to the user
of the product. Do not discard
this document before delivery
to the end user.
Prior to removal, mark the locati
on of
3. Thread webbing through hardware
Thread the webbing as shown (Fig. 6). Threading the webbing may be easier with the Band-It removed.
Locate the ideal placement of Dual Tab Tri-End on the footplate and adjust webbing length so the Dual
Tab Tri-End lays flat. Determine the proximity of the Dual Tab Tri-Ends to the client’s foot; mounting it
closer to the foot will decrease the range of motion allowed at the ankle (Fig. 7).
4. Attach Dual Tab Tri-Ends
Mark the screw placement on the footplates. Remove footplates, if possible, and drill holes as marked,
using Dual Tab Tri-Ends as your drill guide. Make final tension adjustments and drill 16/20 in. screws
through Dual Tab Tri-Ends. For best results, anchor each screw with a nut and washer.
Note: Check manufacturer’s warranty before drilling.
5. Trim webbing
Trim loose webbing tails with sharp scissors and carefully sear ends with a flame to prevent fraying.
Cleaning
Prior to removal, mark the location of the hardware for easy re-installation. Place the Band-It in a pillowcase
or sock and tie off. Machine wash and air dry.
Fig. 6
Fig. 7