Nextiva S1900e Series Installation Guide
www.verint.com/videosolutions September 26, 2006
Covering the S1900e-AS, S1900e-AS-XT, S1950e, S1950e-XT, S1970e,
S1970e-XT, S1970e-R, and S1970e-R-XT.
Casing
Front:
Back:
Installation
1. Plug the video cable of the camera or monitor to the video BNC
connector on the device.
2. Plug the network cable into the LAN 10/100 Ethernet connector on the
device.
3. Power the device.
4. If required, connect the serial port of the device to a camera.
Configuration
c
1. Power the edge device and establish its Ethernet connection.
2. Start SConfigurator.
The SConfigurator window appears.
3. In the General tab, click Program Options.
The Program Options window appears.
4. Check Detect All Units on LAN.
5. Ensure that the VSIP Port is 5510; otherwise, click Default.
6. Ensure that the Discovery IP Address is 255.255.255.255;
otherwise, click Reset to Broadcast.
RS-422/485 Video input or output
Audio input
Audio output
I/O
System status
Reset
12V DC power
SD card slot (on the S1900e-AS
and S1900e-AS-XT only)
RJ-45 Ethernet
