Verona VEFSGE365ND User manual

Quick Start for your New Verona 36” Range
Congratulations on your new Verona Range purchase. Below are a few quick start tips that will familiarize you with your new range.
CONTROLS DESCRIPTION
1. Electronic programmer
2. Left multifunction oven switch knob
3. Left multifunction oven thermostat knob
4. Front left burner control knob
5. Rear left burner control knob
6. Central dual burner control knob
7. Rear right burner control knob
8. Front right burner control knob
9. Right multifunction oven switch knob
10. Right multifunction oven thermostat knob
11. Left oven thermostat indicator light
12. Right oven thermostat indicator light
CONTROLS DESCRIPTION
1. Left oven control knob
2. 60 minute timer control knob
3. Left oven light & fan control knob
4. Front left burner control knob
5. Rear left burner control knob
6. Central dual burner control knob
7. Rear right burner control knob
8. Front right burner control knob
9. Right oven light & fan control knob
10. Right oven control knob
11. Cooling fan failure warning light
VEFSGE365ND
Dual Fuel Double Oven
12
VEFSGG365ND
Gas Double Oven
VEFSGE365N
Dual Fuel Single Oven
CONTROLS DESCRIPTION
1. Oven thermostat indicator light
2. Multifunction oven switch knob
3. Multifunction oven thermostat knob
4. Front left burner control knob
5. Rear left burner control knob
6. Central dual burner control knob
7. Rear right burner control knob
8. Front right burner control knob
9. Electronic programmer
VEFSGG365N
Gas Single Oven
CONTROLS DESCRIPTION
1. Oven control knob
2. Oven light & fan control knob
3. Front left burner control knob
4. Rear left burner control knob
5. Central dual burner control knob
6. Rear right burner control knob
7. Front right burner control knob
8. 60 minute timer control knob
9. Cooling fan failure warning light
Cooktop Burner BTU Output
1. - 6,000
2. - 12,000
3. - 1,000 - 16,000
2,800 (inner crown)
16,000 (inner & outer crown)
Igniting the Cooktop Burners
In order to properly ignite the burners, push & turn the burner
knob counter-clockwise to the position (maximum rate)
indicated by the symbol.
Push in and hold the knob until the flame has been lit. You should hear the gas
flowing and the ticking sound from the burner igniter. Wait about 10 seconds
after the gas burner has been lit before letting go of the knob. This allows the
flame sensor to fully activate and protect you.
If the flame should go out for any reason, the safety valve will automatically
stop the gas flow. To re-ignite the burner, return the knob to the closed
position and wait at least 1 minute, and repeat lighting procedure.
Igniting the Gas Oven
European ovens have extra safety features which may be new to you.
Lighting the oven is quite simple. With the oven knob in the off
position, open the oven door completely. Convection fan must be
turned off. Push the oven knob in and turn it counter-clockwise until it
stops (for bake) or clockwise to broil. After a few seconds, release the
knob. Verify the flame has lit by looking through the opening on the
oven floor for baking and the top of the oven for broiling. Close oven
door and set to desired temperature. There is approximately a 3
minute delay between lighting the small oven on double oven models
and the convection fan turning on.
Using your Oven for the first time
Place oven rack supports, racks & broiler pan in place as described
in your manual under “Oven Accessories installation and removal”.
Turn the oven on Maximum power for both bake and broil for
about 2 hours to remove any traces of grease and odors from the
components. Clean inside of oven with a cloth soaked in water and
neutral detergent and dry.
8
10
2
3
4
5
7
9
6
1
11
8
9
2
3
4
7
6
1
11
5
10
1
2
3
4
5
6
7
8
9
6
7
1
2
3
4
5
8
9

HI
LO
The electronic igniters are incorporated into the knob /valves.

Quick Start for your New Verona 36” Range
The electronic programmer groups together the following functions:
• 12 hours clock with illuminated display
• Timer (up to 23 hours and 59 minutes)
• Program for automatic oven cooking
• Program for semi-automatic oven cooking
Oven Cooling Fan
The cooling fan forces air past the control panel and
through the glass panes of the oven door. The fan is
thermostatically controlled and will turn on when a certain
temperature is reached (Gas Oven) or turn on when
starting the oven (Dual Fuel) and will shut off when internal
temperature falls below a pre-set level which will be for
several minutes after the range has been shut off. The
cooling fan is completely automatic and not adjustable.
Timer
Cooking time
Manual position and cancellation of the inserted cooking program
Numbers up
Numbers down
End of cooking time
Dual Fuel Ranges have many different control settings. Please
review your manual thoroughly to better understand and
benefit from these features. For regular baking or broiling,
the clock must be in MANUAL MODE for the oven to start.
Remember, function selector and temperature knobs
should be returned to the off position when finished.
Available on Dual Fuel Models only.
Operates the Large Oven Only.
Fan Failure Light (Gas Oven Only)
The fan or fan failure light indicates if the cooling fan is
malfunctioning. Under normal operation, this light will
remain off (except for a flicker when turning on the range).
If this light goes on and stays on, turn off the oven and call
for service.
Cleaning the Oven
The secret to cleaning the oven is to wipe up spills and splatters as they occur and clean the
oven with hand dishwashing soap and warm water. For stubborn dirt and grime, place a
shallow pan of water in the oven and set on high for an hour. When the grease and grime
have loosened, use soap and warm water to wipe away. In extreme cases, household oven
cleaners can be used. Always use rubber gloves and eye protection. These chemicals should
not make contact with the stainless steel surfaces as it can discolor the finish.
EuroChef USA maintains a complete part
inventory and can fulfill your request promptly.
For parts or replacement bulbs, call toll free:
631 254-3434, 9:00am - 5:00pm EST.
Re-seating the Burners & Caps
It is very important to check that the burner flame
distributor (F) and the cap (C) have been correctly
positioned –failure to do so can cause serious
problems. If the gas is flowing and the spark igniter is
ticking without lighting, check to see that all burner
caps are seated correctly on the correct burner crown.
If they are not laying flat and level, the burner will not
ignite or function correctly.
Cap Overlaps Burner
Incorrect Cap Placement


Cleaning the Grates, Burners & Burner Caps
Fill a basin with water & hand dishwashing detergent such as Palmolive or Dawn. Soak the
parts in the solution. You can scrub with a nylon brush if necessary. NEVER use scouring
powder or steel wool. NEVER place grates, caps or burners into the dishwasher as the harsh
chemicals can discolor the metal. Once cleaned, dry thoroughly. You may need to wipe the
cast iron with a VERY light coating of vegetable oil to “season” them. Do not let dirt and
grease get baked on for an extended period of time.