Versteel BRATTICE FOLDING TABLE LEGS User manual

2332 Cathy Lane
Jasper, Indiana
47546
800.876.2120
812.482.9318 Fax
www.versteel.com
Thank you for your purchase. Versteel®
hopes that you have many great years
of use from this table and from all of our
products. If you have quesons that
these instrucons don’t answer, please
call customer service at 800.876.2120.
DOCUMENT CONTAINS 1 PAGE
BRATTICE
BRATTICE
®
F O L D I N G T A B L E L E G S
COMPONENTS:
TABLE TOP (1 QTY)
LEG/FOLDING PAN ASSEMBLY (2 QTY)
SCREWS (24 QTY)
ASSEMBLY : STEP 1
PLACE THE TOP FACE DOWN ON THE FLOOR.
(MAKE SURE THE FLOOR IS CLEAN AND FREE
OF ANY DEBRIS.)
ASSEMBLY : STEP 2
LOCATE THE BASE PRE-DRILLS ON THE TOP.
TYPICALLY THE HOLES FOR THE FOUR (4)
CORNERS OF EACH FOLDING PAN WILL
HAVE PRE-DRILLS ON THE TOPS. (DIAGRAM 1)
PLACE LEG ASSEMBLIES OVER THE PRE-DRILLS.
VERIFY THE CORRECT BASE ORIENTATION.
(DIAGRAM 2)
NOTE: WHEN INSTALLING BASES, IT IS
ABSOLUTELY CRITICAL THAT THE TORQUE
SETTING ON THE POWER DRIVER BE AT
THE LOWEST LEVEL NECESSARY TO SET
THE SCREWS IN ALL THE WAY. OVER-
TORQUEING SCREWS WILL RESULT IN
“STRIPPED-OUT” SCREWS, AND BASES
MAY PULL AWAY FROM TOP WHILE IN USE.
THIS IS ESPECIALLY COMMON WHEN HIGH-
VOLTAGE POWER DRIVERS ARE USED WITH
CLUTCH SETTING ON “DRILL/DRIVER.”
IT IS THE RESPONSIBILITY OF INSTALLER TO
ENSURE THAT PROPER TORQUE SETTINGS
ARE USED TO PREVENT STRIPPED-OUT
SCREWS.
1
A
C
B
TOOLS REQUIRED:
2
CONT’D
POWER DRILL/DRIVER
WITH ADJUSTABLE TORQUE
A S S E M B L Y I N S T RU C T I O N S
:
BRATTICE FOLDING TABLE LEGS
ASSEMBLY INSTRUCTIONS :
(4) OUTER HOLES OF TOP PLATE ARE
PRE-DRILLED IN TOP FOR LOCATING

ASSEMBLY INSTRUCTIONS
ASSEMBLY : STEP 3
USING THE SCREWS PROVIDED, ATTACH
EACH BASE TO THE TOP, ONE AT A TIME.
THERE ARE A TOTAL OF TWELVE (12) SCREWS
PER FOLDING PAN: FOUR (4) SCREWS
WITH PRE-DRILLED HOLES AND EIGHT (8)
ADDITIONAL WITHOUT PRE-DRILLED HOLES.
(DIAGRAM 2)
REPEAT WITH OTHER BASE. (DIAGRAM 3)
3
ENJOY YOUR NEW VERSTEEL TABLE!
4
270.INS.BRF 309
BRATTICE
BRATTICE F O L D I N G T A B L E L E G S
ASSEMBLY INSTRUCTION
S :
S :
ASSEMBLY : STEP 4
TEST FOLDING MECHANISM TO ENSURE
PROPER OPERATION.
ASSEMBLY : STEP 5
TURN TABLE UPRIGHT. ADJUST GLIDES TO
LEVEL THE SURFACE. (DIAGRAM 4)