Versteel SLIM-TILT User manual

Thank you for your purchase. Versteel®
hopes that you have many great years
of use from this table and from all of our
products. If you have questions that
these instructions don’t answer, please
call customer service at 800.876.2120.
2332 Cathy Lane
Jasper, Indiana
47546
800.876.2120
812.482.9318 Fax
www.versteel.com
PAGE 1 OF 2
COMPONENTS: QUANTITY:
SLIM TILT TOP 1
BASES 2
TOOLS REQUIRED:
ALLEN WRENCH
BOLTS AND WASHERS
(SUPPLIED BY VERSTEEL)
STEP ONE
PLACE TOP FACE DOWN ON FLAT
SURFACE OR FLOOR. BE SURE THAT THE FACE
IS PROTECTED WITH CARDBOARD OR FURNITURE
BLANKET.
STEP TWO
ORIENT THE BASES SO THAT TEH HOLE PATTERN
ON EACH BASE MATCHES THE HOLE PATTERN ON
THE CENTER STRETCHER BAR. SLIDE THE
BRACKETS ON THE BASES OVER THE BAR
ASSEMBLY INSTRUCTIONS: SLIM-TILT
1
2

ASSEMBLY INSTRUCTIONS: SLIM-TILTPAGE 2 OF 2
STEP THREE
ATTACH BASS TO STRETCHER BAR WITH (4)
5/16-18 X 5/8” BOLTS AND (4) LOCK WASHERS
AS SHOWN. DO NOT TIGHTEN.
STEP FOUR
PULL RELEASE HANDLE TOWARDS YOU
HOLDING ONE OF THE BASES TO PREVENT
FROM FALLING, LAY BASES ON ITS SIDES AS
SHOWN
3
4
STEP FIVE
INSTALL (2) 5/16-18 X 2.5” BOLTS, (2) LOCK
WASHERS AND (2) WASHER PLATES AS SHOWN.
TIGHTEN ALL 6 BOLTS.
STEP SIX
RETURN BASES TO THE INITIAL POSITION.
YOU SHOULD HEAR A “CLICK.” FLIP THE
TABLE OVER AND SET IT ON THE FLOOR.
270.INS.ST 614