Versteel FIXED TABLE User manual

2332 CATHY LANE
JASPER, IN
47546
800.876.2120
812.482.9318 FAX
www.versteel.com
Thank you for your purchase. Versteel hopes that
you have many great years of use from this table
and from all of our products. If you have questions
that these instructions don’t answer, please call
customer service at 800.876.2120.
DOCUMENT CONTAINS 2 PAGES ASSEMBLY INSTRUCTIONS: FIXED TABLE
COMPONENTS: QUANTITY:
TOP 1
TOP MOUNT PLATE 1
COLUMN 1
PLATFORM BASE PLATE 1
TOOLS REQUIRED:
3/16” HEX WRENCH OR DRIVER
CORDLESS SCREWDRIVER AND PH2 BIT
INCLUDED HARDWARE:
COMPONENTS: QUANTITY:
#10 X7/8” PAN HEAD WOOD SCREW VARIES
5/10” 18 X 1” FH SOCKET CAP SCREW VARIES
2-1/2” BLACK GLIDE, SOFT SURFACE 5
2” FELT PAD, HARD SURFACE GLIDE 5
ASSEMBLY: STEP ONE
MOUNT COLUMNS TO TOP MOUNT PLATE.
ALIGN COUNTERSUNK HOLES IN TOP PLATE
WITH APPROPRIATE HOLES IN COLUMNS.
INSERT AND TIGHTEN ALL 5/16” 18 X 1” FLAT
HEAD CAP SCREWS REQUIRED TO PROPERLY
MOUNT COLUMNS.
ENSURE SCREW HEADS ARE FLUSH OR BELOW
TOP MOUNT PLATE SURFACE.

1"
1"
PAGE 2 OF 2 ASSEMBLY INSTRUCTIONS: FIXED TABLE
ASSEMBLY: STEP TWO
PLACE TOP ON FLAT SURFACE,
ENSURE AREA IS PROTECTED TO AVOID
DAMAGE TO THE TOP.
MOUNT BASE TO TOP USING #10 X 7/8”
WOOD SCREWS PROVIDED. DO NOT OVER-
TIGHTEN WOOD SCREWS AS THIS MAY
CAUSE PRODUCT DAMAGE AND VOID THE
WARRANTY.
ASSEMBLY: STEP THREE
PLACE PLATFORM ON UPRIGHTS - DO NOT
LEAVE UNATTENDED. ALIGN COUNTERSUNK
HOLES IN BASE WITH CORRESPONDING
HOLES IN COLUMN. INSERT AND TIGHTEN
ALL 5/16 18 X 1” FLAT HEAD CAP SCREWS
REQUIRED TO PROPERLY MOUNT PLATFORM
TO COLUMNS.
ENSURE ALL SCREW HEADS ARE FLUSH OR
BELOW SURFACE OF PLATFORM.
**USE CAUTION WHEN LIFTING PLATFORM**
***MAY REQUIRE TWO-PERSON LIFT***
ASSEMBLY: STEP FIVE
FLIP TABLE INTO POSITION FOR USE.
ASSEMBLY: STEP FOUR
INLCUDED WITH YOUR BASE ARE TWO (2) GLIDE
STYLES, DETERMINE WHICH STYLE WILL WORK
BEST IN THE BASE APPLICATION ENVIRONMENT
AND APPLY GLIDES EVENLY SPACED AS SHOWN,
1” FROM THE BASE EDGE.
270.INS.PT