4. Tighten the lid of the bucket to prevent water leakage.
Step 2 Continue grinding...
During the second stage, the product will continue to be polished, and it is very
important to check the abrasive during this period.
1. Pour the contents of the bucket into the fine filter screen, and thoroughly clean
the product and the bucket.
2. Refill the product into the barrel.
3. Add the finely ground powder for step 2.
4. Add appropriate amount of water to cover the product to ensure that the barrel
and body are clean and dry.
5. Polish again until the surface of the product is shiny.
Note: Remember don't pour gravel into the household sewer!
Step, 3 polishing!
It's time for polishing.
1. Pour the contents of the barrel into the filter to filter and clean the product.
Make sure not to pour any gravel into the sewer.
2. Thoroughly wash the product and bucket with soap to remove all traces of grit.
You can use a hard-bristled brush or an old toothbrush.
3. Pour the product back into the bucket, add water to cover the surface, and sand
for 5-10 minutes. This step can remove the remaining grit fragments to avoid
scratching the polished product.
4. Clean the product and barrel again.
5. Pour the product back into the bucket, add the polishing powder for step 3, and
add an appropriate amount of water to cover the surface.
6. Make sure that the barrel and body are clean and dry.
7. Polish until the product is bright.
Step 4 Final polishing
Now do the final polishing to give your products the brightest luster, and then you
can put them into the jewelry accessories.
1. Pour the contents of the barrel into the filter to filter and clean the product.
Make sure not to pour any gravel into the sewer.
2. Thoroughly wash the product and bucket with soap to remove all traces of grit.
You can use a hard-bristled brush or an old toothbrush.
