5
There is 20 ft. ( 6.1 m)of 1/4 in. ( 6.35 mm)O.D.polyethylene tubing supplied with the Bottled Water Dispensing
CAUTION：DO NOT USE COPPER TUBING WlTH ANY MODEL OF BOTTLED WATER DISPENSlNG SYSTEMS
water pressure to approx．90-1 00 psi．If you intend to use the BWsystem with one of these brewing machines，
you should remove the brewing machine’s inlet restrictor device．Consult the brewing machine manufacturer for details．
Failure to remove the brewing machine’s restrictor may cause the BW series pump to cycle itself off and on
repeatedly，leading to premature motor failure of the BWunit．This type of failure is not covered under warranty．
the use of a small accumulator tank will be necessary．You may order P/N 30573002B，tank，and P/N 20381-064,
fitting kit．Please contact for more information．
Certain BW models are available without an electricaI plug；this allows for direct connection to the power source，or the
addition of a particular plug type not available from ．Additionally,it may become necessary to replace a damaged
plug．Observe these instructions when connecting your BW unit to a plug or power source．
