6
Care and Cleaning
CAUTION: ALWAYS TURN THE POWER KNOB TO THE OFF POSITION AND DISCON-
NECT THE POWER CORD FROM THE ELECTRICAL OUTLET BEFORE CLEANING.
Daily Maintenance
Lift the Water Tank from Base and empty all water from the Reservoir. Remove the Tank
Cap and drain any water from the Water Tank. Wipe it clean with a soft, damp cloth. The
Mist Nozzle should be removed during cleaning to prevent damage.
Do not immerse the Base in water. Gently wipe the Reservoir with a soft, clean, wet cloth.
Do not attempt to remove or in any other way modify the Water Sensor. Use care when
wiping around the Water Sensor; it is delicate and can be easily damaged. Rinse the
Water Tank with lukewarm water after each use. For storage, wipe dry with a soft, clean
cloth. Keep water away from the Air Outlet.
Do not use detergent to clean any water-containing parts of the humidifier. Detergents
and the film they leave behind can affect the output of the humidifier. Do not use abrasive
cleansers or brushes.
Do not leave water in the Water Tank or Reservoir when unit is not in use as it may result
in the build up of mineral deposits and bacteria that can inhibit the output efficiency of
the humidifier. Please note that if water remains in the Water Tank for more than a day or
two, bacterial growth is possible.
1.
2.
3.
4.
Weekly Maintenance
Thoroughly clean humidifier every week using a solution of bleach and water (one
teaspoon of bleach in one gallon of water). Fill Water Tank partially with this solution, let
stand twenty (20) minutes, shaking vigorously every few minutes, drain and rinse with
clean water until the bleach smell is gone.
Wipe the Reservoir with a soft cloth dampened in the solution. Rinse area thoroughly
before proceeding.
If mineral deposits are evident around the Nebulizer and Water Sensor, clean their surfaces
with a soft, clean cloth and a small amount of undiluted white vinegar. If necessary for
removal of mineral deposits, mix a solution of 50% white vinegar and 50% water and fill
the Base with enough solution to cover the Nebulizer. Allow it to soak for an hour. Then
use a cotton swab to gently loosen buildup on the Nebulizer. Rinse out the Reservoir and
wipe clean. Do not touch Nebulizer with bare fingers as any fingerprints or other
residue can affect mist output. Be careful not to damage the Water Sensor.
Remove VapoPad when finished. Do not pour water or detergent into the Scent Pad slot.
Scent Pad slot can be cleaned with a cotton swab only.
All surfaces should be thoroughly cleaned with water prior to reuse.
1.
2.
3.
4.
5.
End of Season Maintenance
Follow above weekly cleaning procedure at the end of the humidification season, or when
the humidifier will not be used for several days, being sure to dry all parts, including the
inside of the Water Tank. Do not store with water inside.
Leave Tank Cap partially loosened during storage to prevent Tank Cap and gasket from
sticking together. This will prolong the life of the gasket.
Clean the Water Tank and Base after long periods of storage.
1.
2.
3.
