Viconics VT8000 Series User manual

VT8000 Series Room Controllers
User Interface Quickstart Guide

2|VT8000 Series User Interface Quickstart Guide
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: [phone] | Fax: [phone] | www.viconics.com | [email protected]
February 2016
Date
Time
Occupancy Status
Fan Speed
Adjust by pressing the Fan Mode icon
on the bottom
Auto Low Medium High
Current System Status
Cooling Heating Auto Off
Up Arrow
Press to raise temperature
Temperature Setpoint
Current Temperature
Room Indoor Humidity
Outdoor Temperature
Down Arrow
Press to lower temperature
System Mode
Select system mode
Temperature Units
Switch between Celsius or Fahrenheit
Help
Tap to view the help screen
Language
Tap to select your preferred language
Fan Mode
Select fan mode
Some of the parameters below are model dependent and may not appear on all room controllers.
General Notes
1. When any change is made to a parameter (temperature setpoint, fan speed etc.), the value is automatically saved in the room controller’s
memory.
2. Arrows, when pressed for more than 2.5 seconds, increment/decrement at higher speed.
Network Message

VT8000 Series User Interface Quickstart Guide | 3
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: [phone] | Fax: [phone] | www.viconics.com | [e-mail]
February 2016
On/Off shows during
heating or cooling mode
only. Use this button to
quickly stop or start the
system in the desired
mode.
The Date and Time will
appear only if properly set Automatic Heating / Cooling mode
In Auto mode, the setpoint located directly
under the blue line represents the tempera-
ture which, when reached, will
trigger the system to enter cooling mode.
Similarly, the setpoint located directly above
the red line is the temperature which, when
reached, will put the system into heating
mode.
During setpoints adjustment, the large digits
are temporarily used to display the Cooling
or Heating Setpoints.
Normal temperature display resumes after
the setpoints are adjusted and the adjusted
heating and cooling setpoints are displayed
in the setpoint bar.
Heating mode
In Heating mode, the value displayed in the
setpoint bar is the current heating setpoint.
To adjust it - use the up and down arrows.
During setpoint adjustment, the large digits
are temporarily used to display the new
heating setpoint.
Normal temperature display then resumes
and the actual occupied heating setpoint is
displayed in the setpoint bar.
The fan button lets you control
the speed of the fan.
Tap to switch between Auto,
Cooling, Heating and Off modes
Variations