Victorian Plumbing Milton WSSL1 User manual

We recommend this product is installed by a fully qualified
tradesperson.
Tools Required (not supplied)
Pencil; Tape measure; Screwdriver appropriate to fixings;
Spirit level; Drill; Masonry drill bit appropriate to fixings,
Ceramic drill bit (optional) appropriate to fixings.
Home Safety Advice
• It is recommended that two people fit this product to
ensure that it is fitted safely.
• Always take care when using power tools, particularly in
the bathroom.
• Always check for hidden cables and pipework before
drilling and take extreme care if there is any water in the
working area.
• It is advisable to use a residual current circuit breaker
(RCCB).
• Always wear suitable eye protection when drilling.
• If the product is to be fitted on a ceramic tiled wall, a
ceramic drill bit should be used.
• Always ensure that the drill hole passes through the
central tiled area rather than through the grouted area.
To prevent damage to the tile, mask the area around the
hole with tape before drilling.
• Do not strike the product with hard or sharp objects.
• Warning! This product has been designed as a seat only
and should not be used for any other purposes.
Maximum Weight –160 kg evenly distributed about the
seat.
Product Location
Shower seats are only as strong as the wall to which they are
fixed and the fixings that are used. For different wall types you
will need to ensure that you are using the correct type of fixing for
the material of the wall. The addition of backboards on the
outside of the wall or appropriate strengthening of internal
structures may be required to provide adequate wall strength.
Product Care
To retain the best quality finish, clean product regularly with a
soft damp cloth. Do not use abrasive or chemical cleaners as
these will damage the product. Dry the shower seat after use.
Note: If the wall is made of lightweight thermal blocks, aerated
hollow brickwork, or prefabricated partitions, even the most
appropriate fixings may not be able to withstand the loads which
can be suddenly applied to shower seats.
Recycling and disposal
Please recycle the packaging in accordance with your local
government regulations on waste handling and follow the same
advice at the end of the products’ life.
For more Information
Visit: victorianplumbing.co.uk

1
To ensure the correct installation, it is
recommended using a qualified, competent
installer to install the product.
The shower tray and wall coverings, such as tiles,
should be fully installed, sealed and cured.
.,,,,,, .
.,,,,,,
.,,,,,, .
.,,,,,,
Once you have marked the
holes on the wall, drill and
plug the holes using the
appropriate drill bits, tools
and tool settings
2
Place the seat at the desired height and in the desired
location. The legs are adjustable by unclipping the pin,
adjusting the leg and then re-inserting the pin, In addition,
one of the feet on the lower legs is height adjustable via a
screw thread.
s
Then screw the seat in place.
3
Make sure that the seat is level and stable in all planes in its
lowered position. Mark the holes onto the wall.
Cus.t.om<l1 Care Guide
•It is important to clean your shower seat after every use. wipe
down all plastic and metal Parts with a soft cloth.
•Do not allow lime scale to build up in hard water areas.
•Ensure that any residual water is removed after every use.
•Do not use abrasive products on any surfaces.
•Bathroom products are vulnerable to add attack and some
household consumables such hair dye, disinfectants , denture
cleaners etc can contain such adds. Contact with these materials
should be avoided .
•This instruction guide is for illustration purposes and may not be
an exact representation of the physical product.
•For full terms and conditions, please refer to the manufacturer