Victorian Plumbing Arezzo AZ01MBWHI User manual

WALL-MOUNT SINK INSTALLATION
BEFORE YOU BEGIN
1. We recommend consulting a professional if you are unfamiliar with installing bathroom fixtures and plumbing. We
accept no liability for any damage to the floor, walls, plumbing, vanity cabinet, sink, counter top, or personal injury
during installation.
2. Observe all local plumbing and building codes.
3. Unpack the product then read these instructions before proceeding. And Inspect the sink for damage. If any
damage is found, contact our Customer Relations team.
GETTING STARTED
1. Ensure that you have gathered all the required materials that are needed for the installation.
2. Because wall construction and materials vary from home to home, we does not always provide mounting hardware.
The appropriate mounting hardware can be purchased from your local hardware store.
3. The sink must be fastened to load bearing wall. And the wall mount brackets must be strong.
4. For the following instructions, it is assumed that the in-wall plumbing has already been prepared.
5. Before you start your wall-mount sink installation process, shut the water off to avoid flooding or leaking.
TOOLS AND MATERIALS
INSTRUCTION MANUAL
Thank you for purchasing this natural stone wall-mount sink. This product is carefully
packaged, inspected, and tested to ensure safe operation and delivery. The following
instructions and safety guidelines will enable you to use the product for trouble-free operation.
Please read the instructions and safety guidelines entirely before using the product.

CLEANING AND MAINTENENCE
We recommend that you regularly clean your stone sink with a mild dish detergent or stone cleaner. After each use,
wipe the basin dry with a soft cloth. Do not allow mineral deposits such as iron, salt, lime, or soap to build up on your
sink. Refrain from using acidic household cleaners, wipes with harsh chemicals, or abrasives, as these will damage
stone. Seal the stone with a quality sealer, such as Stone Tech, to prevent staining and discoloration.
Thank you for choosing our natural stone sink
INSTALLATION
1. Hold the sink up at the desired installation location.
Ensure that the sink is level, then mark the location of
the anchor holes.
Important: The sink should be anchored to load
bearing finished wall. We recommend consulting a
professional if you are unfamiliar with this type of
installation.
2. Move the sink away from the installation location.
For convenience, install the waste onto the sink
before moving on.
3.Before drilling, ensure there are no hidden cables
or pipes in the wall. Then drill pilot holes at the
marked locations and insert the anchors into the
drilled holes.
Important: Attaching the sink to a hollow wall could
result in future injury or extensive damage to your
home if an accident were to occur. Consult a
professional if you are unsure, or unfamiliar with this
type of installation.
5. Apply silicone on the anchor where it meets the
bottom of sink. Move the sink back into position at
the installation location. Attach the sink to the
anchor. Complete the installation by applying a thin
bead of silicone sealant around the back of the sink,
where it meets the wall. This will prevent water from
getting behind the sink, which could damage dry
wall.
6. Allow the sealant to fully dry for 24 hours.
4. Proceed to the installation of the drain trap, water
supply lines. Refer to their respective installation
instructions for guidance if needed.