Victron energy SmartShunt SHU050150050 User manual

Loads
&
Chargers
Loads
&
Chargers
Page 1 Rev: 03
1
22 3
4 5
• Working in the vicinity of a lead acid battery is dangerous. Batteries can generate explosive gases during
operation. Never smoke or allow a spark or flame in the vicinity of a battery. Provide sufficient ventilation around
the battery.
• Wear eye and clothing protection. Avoid touching eyes while working near batteries. Wash your hands when
done.
• If battery acid contacts skin or clothing, wash them immediately with soap and water. If acid enters an eye,
immediately flood the eye with running cold water for at least 15 minutes and get medical attention immediately.
• Be careful when using metal tools in the vicinity of batteries. Dropping a metal tool onto a battery might cause a
short circuit and possibly an explosion.
• Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a battery. A
battery can produce a short circuit current high enough to melt objects such as rings, causing severe burns.
• Connect the negative battery terminal to the
SmartShunt BATTERY MINUS terminal
• Connect the negative DC electrical system
terminal to the SmartShunt SYSTEM MINUS
terminal
• Connect the power cable between the positive
battery terminal and the SmartShunt Vbatt+
terminal
• SmartShunt
• Two power cables
• The full manual is available online
Battery safety warnings
SmartShunt
Quick installation guide
Loads
&
Chargers
Introduction Connect battery negative
Connect power cableConnect DC load negative
www.victronenergy.com.
au/battery-monitors/
smart-battery-shunt
SmartShunt manual:
www.victronenergy.com.
au/battery-monitors/
smart-battery-shunt
SmartShunt manual:

Loads
&
Chargers
Loads
&
Chargers
Loads
&
Chargers
SmartShunt
Quick installation guide
Page 2 Rev: 03
66 77
8 9
10 1111
• Connect the power cable between the positive
terminal of the second battery and the
SmartShunt Aux terminal
• Connect the negative of the second battery to the
SmartShunt SYSTEM MINUS terminal
Monitoring voltage of a second battery Monitoring midpoint of a battery bank
Monitoring battery temperature
Make essential VictronConnect settings
Connecting to a GX device
Download and connect VictronConnect
• Connect the power cable between the battery
bank midpoint and the SmartShunt Aux terminal
• The red power cables (included) are not used.
• Connect the (not included) temperature sensor
ASS000100000 to the positive battery terminal.
• Connect the temperature sensor red wire to the
B1 terminal and the black wire to the B2 terminal.
• Download VictronConnect
• Connect to the SmartShunt
Optional Optional
Optional Optional
• Connect the (not included) VE.Direct
cable ASS03053xxxx between the
VE.Direct ports of the SmartShunt
and the GX device
• Set the battery capacity
• Set the functionality of the auxiliary input (if used)
• Set the charged voltage parameter:
Additional settings for lithium batteries:
• Set the charge efficiency at 99%
• Set the Peukert exponent at 1.05
www.victronenergy.com/
live/victronconnect:start
VictronConnect manual:
www.victronenergy.com/
live/victronconnect:start
VictronConnect manual:
https://ve3.nl/Venus-OS:start
Victron GX product range:
https://ve3.nl/Venus-OS:start
Victron GX product range:
Loads
&
Chargers
Loads
&
Chargers
Nominal battery
voltage Charged voltage setting
12V
24V
36V
48V
13.2V
26.4V
39.6V
52.8V
Nominal battery
voltage Charged voltage setting
12V
24V
36V
48V
13.2V
26.4V
39.6V
52.8V