ViewSonic ViewBoard VB-WPS-001 User manual

ViewBoard® Cast Button
VB-WPS-001 & VB-WPS-003
User Guide
Brugervejledning
Handleiding
Käyttöopas
Manuel utilisateur
Bedienungsanleitung
Manuale utente
Brukerveiledning
Podręcznik użytkownika
Руководство пользователя
Guía del usuario
Användarguide
Kullanım Kılavuzu

Device Requirements
• Windows 7/8/10
• MacOS 10.10 or later
• ViewSonic IFP/CDE series device(s) with vCastReceiver
installed and acvated.
• VB-WPS-001: Device supports fully featured USB
Type-C funcon that covers USB & DP.
• VB-WPS-003: Device supports HDMI & USB Type-A.
Pairing
Windows PC and MacBook Pairing
VB-WPS-001
Figure 1
VB-WPS-003
Figure 2
1. Plug-in the ViewBoard® Cast Buon into your
Windows PC or MacBook to pair.
• For VB-WPS-001: Please plug-in to the USB Type
C port (Figure 1).
• For VB-WPS-003: Please plug-in to both the HDMI
out and USB Type A ports (Figure 2).
2. If it is the rst me to pair the ViewBoard® Cast
Buon with your Windows PC, please double
click “ViewBoard Cast.exe” in: PC > CD Drive >
ViewBoard Cast.
NOTE: If running on a MacBook, please enter the
user password to access the applicaon
installaon permission.
3. For PC, with the applicaon installed, ViewBoard®
Cast will launch automacally aer the ViewBoard®
Cast Buon is plugged into the PC.

4. The pairing dialogue box will pop up on your PC.
Please enter the Network Name, Password, and
the vCastReceiver IP address shown on the IFP/CDE
device(s) home screen.
5. Click OK to complete the pairing of the ViewBoard®
Cast Buon and the IFP/CDE device(s) (Figure 3).
Figure 3
6. Remove the ViewBoard® Cast Buon and then plug
it in again to start sharing (Figure 4).
Figure 4

7. If the ViewBoard® Cast Buon has been paired,
and you would like to pair it with another IFP/CDE
device, please click the “Pairing-Switch Buon” at
the boom right corner (Figure 5) and re-enter the
network informaon to re-pair the ViewBoard® Cast
Buon (Figure 6). Aer the ViewBoard® Cast Buon
is re-paired, please remove it and plug it in again to
start sharing.
Figure 5 Figure 6
ViewBoard IFP/CDE Pairing
You can also plug-in the ViewBoard® Cast Buon into
IFP/CDE device(s) to pair if the IFP/CDE device(s) is
connected to a LAN (Ethernet cable).
For VB-WPS-001:
1. Aach the USB Type C to USB Type A adapter to the
VB-WPS-001 ViewBoard® Cast Buon (Figure 7).
2. Then plug the ViewBoard® Cast Buon into the IFP/
CDE device’s USB port for pairing.
Figure 7
NOTE: The USB Type C to USB Type A adapter is for
oponal IFP/CDE device pairing only.

For VB-WPS-003:
1. Plug the USB Type A cable into the IFP/CDE device’s
USB port for pairing.
2. A “Pairing” dialogue box will appear.
3. Enter the Network Name and Password, then select
Save to pair (Figure 8).
Figure 8

Screen Sharing
Figure 1
Figure 3 Figure 4
Figure 2
NOTE: Ensure the ViewBoard® Cast Buon is
plugged into your Windows PC/MacBook.
1. When the ViewBoard® Cast Buon is connecng to
your device, the LED indicator will be ashing blue.
Your device is ready for screen sharing when the
LED indicator changes to stac blue (Figure 1).
2. Tap the buon of the ViewBoard® Cast Buon to
share your device’s screen to another display. The
LED indicator will change from blue to white when
it’s successfully connected and sharing (Figure 2).
3. If the LED indicator only ashes white and fails to
connect, please ensure the IFP/CDE device(s) are
working correctly and that the pairing informaon is
entered correctly (Figure 3 and 4).

Regulatory and Service Informaon
FCC Compliance Statement
NOTE: NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protecon against harmful
interference in a residenal installaon.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instrucons, may cause harmful interference
to radio communicaons. However, there
is no guarantee that interference will not
occur in a parcular installaon. If this
equipment does cause harmful interference
to radio or television recepon, which can
be determined by turning the equipment
o and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help
Changes or modicaons not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operaon.

This device is acng as slave and operang in the
2.4 GHz (2412 ~2462 MHz) band. Ad Hoc funcon
is supported but not able to operate on non-US
frequencies.
RF Exposure Warning Statements:
This equipment complies with FCC radiaon exposure
limits set forth for an uncontrolled environment.
This equipment shall be installed and operated with
minimum distance 65mm between the radiator & body.
Canadian Regulatory Statements
This device contains licence-exempt transmier(s)/
receiver(s) that comply with Innovaon, Science and
Economic Development Canada’s licence-exempt RSS(s).
Operaon is subject to the following two condions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operaon of
the device.
L’émeeur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d’Innovaon,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L’exploitaon est autorisée aux deux condions
suivantes :
(1) L’ appareil ne doit pas produire de brouillage;
(2) L’ appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
suscepble d’ en compromere le fonconnement.
Radio Frequency Exposure Statement for IC
The device has been evaluated to meet general RF
exposure requirements. The device can be used in
mobile exposure condions. The min separaon
distance is 65mm.

Déclaration d’exposition aux radiofréquences pour IC
L’appareil a été évalué pour répondre aux exigences
générales en maère d’exposion aux RF. L’appareil peut
être ulisé dans des condions d’exposion mobiles. La
distance de séparaon minimale est de 65mm.
CE Conformity for European Countries
The device complies with the EMC Direcve
2014/30/EU and Low Voltage Direcve
2014/35/EU. and Radio Equipment Direcve
2014/53/EU
The full Declaraon of Conformity can be found at the
following website:
hps://www.viewsonicglobal.com/public/products_
download/safety_compliance/IFP/VB-WPS-001_VB-
WPS-003_CE_DOC.pdf
The following informaon is only for EU-member
states:
The mark shown to the right is in compliance
with the Waste Electrical and Electronic
Equipment Direcve 2012/19/EU (WEEE).
The mark indicates the requirement NOT
to dispose of the equipment as unsorted
municipal waste, but use the return and
collecon systems according to local law.

Customer Service
For technical support or product service, see the table
below or contact your reseller.
NOTE: You will need the product’s serial number.
Country/
Region Website Country/ Region Website
Asia Pacic & Africa
Australia www.viewsonic.
com/au/ Bangladesh www.viewsonic. com/bd/
中国 (China) www.viewsonic.
com.cn
香港 (繁體
中文)
www.viewsonic.
com/hk/
Hong Kong
(English)
www.viewsonic.
com/hk-en/ India www.viewsonic. com/in/
Indonesia www.viewsonic.
com/id/ Israel www.viewsonic. com/il/
日本 (Japan) www.viewsonic.
com/jp/ Korea www.viewsonic. com/kr/
Malaysia www.viewsonic.
com/my/ Middle East www.viewsonic. com/me/
Myanmar www.viewsonic.
com/mm/ Nepal www.viewsonic. com/np/
New Zealand www.viewsonic.
com/nz/ Pakistan www.viewsonic. com/pk/
Philippines www.viewsonic.
com/ph/ Singapore www.viewsonic. com/sg/
臺灣 (Taiwan) www.viewsonic.
com/tw/ ประเทศไทย www.viewsonic. com/th/
Việt Nam www.viewsonic.
com/vn/
South Africa &
Maurius
www.viewsonic.
com/za/
Americas
United States www.viewsonic.
com/us Canada www.viewsonic. com/us
Lan America www.viewsonic.
com/la
Europe
Europe www.viewsonic.
com/eu/ France www.viewsonic. com/fr/
Deutschland www.viewsonic.
com/de/ Қазақстан www.viewsonic. com/kz/
Россия www.viewsonic.
com/ru/ España www.viewsonic. com/es/

Country/
Region Website Country/ Region Website
Türkiye www.viewsonic.
com/tr/ Україна www.viewsonic. com/ua/
United Kingdom www.viewsonic.
com/uk/

C0 M91 Y72 K24
Process Color
C0 M0 Y0 K100
Process Color
C0 M91 Y72 K24
Process Color
Pantone Black C
Spot Color
Pantone 187 C
Spot Color
Pantone Black C
Spot Color
Pantone 187 C
Or Spot Color