0℃~50℃
0.086 dB/m to 0.14 dB/m
Operating Instructions
1. Working principle
The sensor sends a signal to the paired main panel when the built-in smoke sensor is triggered.
2. Pairing with main panel
①Scan the QR code on this accessory using the App.
②The pairing result can be confirmed in the App.
Press the test button.
*Test: The alarm is provided with a test button. Press this until the alarm signal sounds. The signal stops once the
button is released. Test the alarm at least once a week.
Appearance
Features
The wireless smoke sensor is an accessory of the VIGILATE smart alarm system.
Thanks to its unique design and MCU that workswith photo-electricity signals,it is dust-proof, pest-proof, anti-optical
interference, etc. This product responds well to smoldering and burning smoke.With a build-in photoelectric smoke sensor, it
will trigger an alarm when the smoke density reaches the alarm threshold.
Parameters
Installation & Notice
• Open the case and insert the battery.
•Pairing it with the main panel before installing.
•Choose a proper position, normally the center of the detection area ceiling is recommended. Please fix the sensor base into
the chosen position with screws. Be sure it is fastened tightly.
•Avoid installing sensor in places with:
• stagnating smoke
• heavy dust, heavy water mist or heavy oil mist
• great humidity(>95%)
• high wind speed(>5m/s)
•To ensure the sensitivity, please clean the sensor surface with soft bristled brush every 6 months. Make sure to turn off the
power before cleaning.
• Contact your dealer when there is any problem about the product. DO NOT attempt to repair the sensor personally.
•The sensor can reduce the happening rate of disasters. But there is no guarantee that you will be completely protected.
For your safety, please use this sensor properly and be vigilant in your daily life.
Please regularly clean the sensor to keep it free of dust particles and ensure it is in proper working condition. If the
alarm fails to operate correctly, please contact the dealer .
• Working Voltage DC 9V
• Battery 9V Alkaline
• Working Current ≤50mA
• Standby Current ≤20µA
• Alarm Sound ≥ 85dB/30cm
• Product Certification BS EN 14604: 2005
•
• Transmission Distance Without obstacle 500m
• Transmission Frequency 433.92MHz
• Working Temperature
• Humidity 10%~90%rh (non-condensing)
• Weight 98.7g (battery not included) 134.5g(battery included)
• Dimension Φ107x34mm (LxWxH)(±0.1mm)
Test Button &
LED Indicator
Back Cover
buzzer
Smoke Sensitivity
Hint: How to trigger
