Vinh Quang VQE005 Dragon Fly User manual

Made in Vietnam
VQ MODELS DRAGON FLY ARF
ASSEMBLY INSTRUCTIONS ADDENDUM
Kit Product Number VQE005
CHECKING THE FIT OF THE COWL
This addendum supplements the Instruction Sheet included with your
Dragon Fly ARF. Please read through both this addendum and the Instruction
Sheet before starting.
This addendum covers installation of the two forward fuselage fairings and
the cowl. Please follow the procedures in this addendum carefully.
Global Hobby Distributors
© 2008, All Rights Reserved
q Beforeinstallingthetopandbottomfuselagefairings,double-checkthatthecowltsproperlyovertherewall.Thecowlmounting
ringshouldslideovertherewall,butnotttootightly.Ifitdoesn'tslideovertherewall,pleasefollowtheprocedurebelow.
INSTALLING THE FUSELAGE FAIRINGS
q Whenyouinstallthetopandbottomfuselagefairings,makesurethatthe
front of the fairings are installed behindtherewall.Donotinstallthefuselage
fairingsovertheedgesoftherewall.
INSTALLING THE COWL
q Installthecowlafterinstallingthefuselagefairings.Whenalignedproperly,
the back edge of the cowl mounting ring should be butted up against the
frontofthefuselagefairings.Thecowlmountingscrewsarethenthreaded
throughthecowlmountingringandintotheedgeoftherewall/fuselage
q Ifthecowlmountingringdoesnotslideovertherewall,lightlysandthe
topandbottomcurvededgesoftherewalltomatchthecurvesofthecowl.
Removesmallamountsofmaterialattimeanddouble-checkthetoftento
ensurethatyoudon'tremovetoomuchmaterial.
IMPORTANTItmaybenecessarytoalsolightlysandtheinsideedgeofthe
cowlmountingringtoremoveanyexcessberglassresinthatmightinterfere
withslidingthecowlmountingringovertherewall.