Specifications
• Available in black or white finish
• Bar mounting system included
• 6 ½” Polypropylene woofer with 1” Mylar tweeter
• Adjustable Line Transformer: 4/8/16/30w (70V)
• Impedance: 8 ohms
• Rated Power: 50W – 100W (max)
• Frequency response: 55Hz – 20Khz
• Sensitivity: 89dB
• Size: H x W x D (inch): 11.2” x 8.1” x 7.1”
Installation Instructions
• Recommended wiring: weather proof copper wire (or heavier)
• Ensure that the speakers are installed on a surface sturdy
enough to support their weight. Fasten properly and securely.
• Take into account the targeted listening area and potential
safety hazards when choosing speaker installation and
location.
• Please refer to the following illustrations for assembly and
installation instruction.
-2-
www.vinsonacoustics.com
Installation Diagrams
Assembly Example
Installation Example
• All speakers have to be connected to the constant voltage line (see
figure below). The output power can be adjusted at the rear of the
speaker. (70 Volt installation)
• Check that the transformer is set to be equal or lower than the
nominal power supplied by the amplifier (70 Volt installation)
• For normal residential systems that require 8 ohm speakers,
adjust the dial on the rear of the speaker to 8 ohm and
connect to receiver. (see figure below)
-3-
www.vinsonacoustics.com
