Vinson Acoustics VAC6DS User manual

3
CONNECTIONS
Underpower Vs. Overpower
Stereo Collection
Most speaker damage is caused by amplifiers with too little power (wattage).
1
2An overdriven amplifier clips the waveforms and leads to speaker distortion.
3Clipping is usually audible and it may vary from a harsh sound to a fuzzy or
unclear sound.
4If you hear the clipping at high volume levels, turn down the volume until the
distortion is gone.
5Damage caused by operating the speakers at distorted volume levels is not
covered by the warranty.
SYSTEM GERNERAL SPECIFICATION
Woofer
Tweeter
Frequency Response
Sensitivity(1M/1W)
RMS Power
Nominal lmpedance
Transformer
Product Dimensions
Cutout Size
0.75" SILK DOME
65Hz-20kHz
85dB
50W
8Ω
/
Ø263.5x101mm(Ø10.4"x4")
Ø232mm(Ø9.1")
6.5" PP Cone
Product Weight 1.4KGS
2-CHANNEL AMPLIFIER WITH 8Ω OUTPUT
Observe Correct Polarity for Maximum Bass Performance
LEFT
8Ω
RIGHT
8Ω
VAC6DS
IN-CEILING
SPEAKER
www.VinsonAcoustics.com

2
INSTALLATION
1.
2.
3.
4.
5.
Dog Leg
USER
MANUAL
user manual
1
When the speakers are installed in the ceilings, ensure the ceiling structure is
reliable and that the speakers are firmly attached.
Install the speaker in a location that can structurally support the weight of the
speaker and its mounting hardware.
Otherwise it may result in the unit falling down and causing personal injury.
Do not use nails, adhesives or other unauthorized devices.
Long-term use and vibrations may cause it to fall easily.
Do not touch or bump the woofer and tweeter. If these are damaged, the sound
will be distorted.
Do not listen to sound at a very high level when you are changing the input
source (for example, to tune FM / CD)
Installation or removal of cables should make sure that the power amp /
amplifier device radio is turned off.
SAFETY INSTRUCTIONS
1
2
3
4
5
speaker
PACKING LIST