Viozon UP-6A User manual

Additional Parts Box
UP-6A
User Manual Scan QR code below for
more products from viozon
X 1
Base Stem
X 1
Base Legs
X 1
Arm
X 1
Pole
X 1
Holder
X 1
Post Cap
X 1
Connector
X 1
Screws (M10)
X 1
Screws(M5*16)
X 2
Screws(M6*10)
6mm 5mm 4mm
Hex Wrench
WARRANTY SERVICE
FEEDBACK
Never worried when you choose viozon products We offer the
best after-sale service to our customer, it only takes few minutes.
And then you will get a complete service like The installation guide,
Technical support, New product iteration, buy New similar products
in advance , promotions, and warranty service from Viozon.
Viozon is focus on high-standard product, we believe Customer
drive our product upgrades. And write a review that sharing your
experience will help other customers , and this will give us great
encouragement and confidence.
And if you have any questions, please feel free to contact us
without hesitate.
Share it?
Let us know with a customer review.
Just send you name and order number to
US: [email protected]
EU: [email protected]
FOR HELP PLEASE CONTACT US:
Facebook: Viozon EU: [email protected]
US: [email protected]
www.vio-zon.com
This product contains small parts, keep these away from children.

Using screw M6*10 to fix the base legs to the base stem.
Using Hex Wrench 4mm fully
tighten the screw to make sure
the pole doesn’t wobble.
Using screw M10 to fix the pole to the base stem.
Assembling the arm with the pole,adjust to
the right position and fix it with the screw.
Assembling the post cap.
Pulling the holder to grip your advice.
Open cable clip two sides.
If you feel the pitching angle too tight or too loose when
adjusting the mount,please adjust the Screw.
Using M5*16 screw to fix the connector
with the back hole of holder.
As shown in the pic, assebling the connector
and fix it with the screw.
3
3
3
3
Max:44.5” (1130mm)
Min:8.5” (215mm)
As shown, the pole with
groove should face out.