Vision Luminator LM400+ Series User manual

To prevent a fire or
malfunction due to a
short, be sure to
cover the unused
connector with the
included rubber cap.
16 Selectable Scanning Patterns
To change patterns, press product button while Ignition is ON.
3 Selectable Speeds
To change speeds, press product button while Ignition is OFF.
NOTE1: Pattern will change with each button press.
NOTE2: Flash memory saves your selection when power is cut.
www.kiramek.com
WARNING!
®LM400+
SERIES
Illuminates when alarm is Armed. Turns off when Disarmed.
BLK Connect to the (–) car battery terminal or the metal
body of the car itself.
YEL Connect to the alarm’s (–) Ground-When-Armed output.
RED Connect to constant (+)12v.
The Ultimate in Car Security
DO NOT illuminate product
while driving.
IMPORTANT!
CONSUMPTION 5mA (avg.)
For addition help, please consult your alarm system’s manual.
Installation A: With an alarm
GAP-2
INSTALL “B” REQUIRES PURCHASE OF THE OPTIONAL GAP-2
If you install to IGN without the GAP-2, engine noise could damage the LED over time.
BLK
RED
BLK
RED
YEL
YEL
GRN/WHT
Installation B: Without an alarm
(Retail: ¥1,600)
NOTE:DONOTusetheinstructionsinthisboxifyouwanttheLM400+toworkwithanalarm!
To (–) Ground.
To (+)12v power.
To (–) Ground.
To (+)12v power.
To Ignition, ACC or car stereo fuse.
(Must be (–) GND when engine is off.)