Vista VSBCMC6LED User manual

INSTRUCTION MANUAL
VSBCMC6LED(Colour/Monochrome) VSBMC6LED(Monochrome)
Thank you for choosing this high quality camera, before attempting to connect or operate this product, please
read and follow these instructions
General
These CCD video cameras employ a 1/3" CCD solid-state imaging device, which provide high reliability.
These bullet cameras can be easily installed in both internal and external locations along with its very low
current consumption of 140mA the camera is not only simple to install but achieves an excellent reliability
record.
Features
1. High quality picture.
2. Indoors or out-door use.
3. Long life and high reliability.
SPECIFICATION
VSBMC6LED VSBCMC6LED
Image sensor 1/3”Monochrome CCD 1/3" Colour/Monochrome Ex-View CCD
Number of Pixel 500(H) x 582(V) <CCIR> 500(H) x 582(V) <PAL>
Resolution 420TV lines 380 TV lines
Min. Illumination 0Lux (IR LED ON)
S/N Ratio More than 50dB More than 45dB
Electronic Shutter 1/50 to 1/100,000 sec.
White Balance N/A Auto white balance
Video Output 1.0Vp-p composite, 75Ω
Standard Board Lens 6mm / F2.0
Lens Angle 32° (V) 42° (H)
Power Source DC12V+ 10%
Current Consumption 120mA (LED Off) & 180mA (LED On)
Operating Temp -10°C ~ +40°C
Storage Temp -20°C ~ +60°C
IR LED 6 Unit IR LED up to 5m
IR LED wavelewngth 850nm
IR LED half angle ±15 degree
Dimension (mm) 40Ø x 110(H) mm
Box Dims 70(W) x 70(L) x 142(H)
Weight 329g incl. bracket
Weight boxed 381g
Mounting Bracket 40(W) x 75(H)

Major operating controls and functions
1. DC12V Input Terminal: For connected to power supply.
2. Video Output Connector (VIDEO OUT): For connected to video terminal.
Connections
1. Connect to the power cord:
This is to connect camera to a 12V DC regulated power supply. (2.1mm centre positive)
2. Connect to video input:
This is to connect camera to 75Ωvideo terminal CCTV quality 75 Ωcoaxial cable via a BNC connector.
Standard Accessories
1. Main Body (1)
2. DC-BNC Connector (1)
3. Instruction Manual (1)
4. Mounting bracket (1) and screws (3)
1. A regulated DC 12V power supply is recommended for use with this camera for the
best picture and most stable operation. An unregulated power supply can cause
damage to the camera.
2. It is recommended that the camera is used with a monitor that has a CCTV quality 75
ohm video impedance level. If your monitor is switched to high impedance then please
adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal components.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reflective light, which may
cause smear on the picture and possible damage to the CCD.
Vista
Norbain House
Eskdale Road
Winnersh Triangle
WOKINGHAM
Berkshire
RG41 5TS
Tel: [phone]
Fax: [phone]
www.vista-cctv.com