vita London Trellis User manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346 (Mon. to Fri. 8:00 AM to 5:00 PM EST).
1. Arched Top Rail (1) - 10857
2. P ost Caps (2) - 10748-1
3. P ost - Left (1) - 10858
4. P ost - Right (1) - 10859
5. Vertical Spindles (3) - 10860
6. Horizontal Spindles (7) - 10861
7. Bottom Rail (1) - 10862
8. Ground Mounting Extensions (2) - 10863
9. 5/8”(16 mm) Self-Auguring Stainless Steel Screw (12) - 20016
Tools You Will Need
• Cordless Drill
• Hammer
• Tape Measure
• Level
• Shovel
General Information
•Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 5’x 8’ (1.5 m x 2.4 m) for unobstructed assembling.
•You should not need to use excessive force when assembling component.
The London Trellis
Please read through before starting assembly.
ASSEMBLY INSTRUCTIONS
1
1
2
9
Not to Scale
7
3
5
6
IMPORTANT: CHECK THE INSIDE OF YOUR POSTS FOR ALL MATERIALS.
V2.3/061020
8
4.5 in
(11 cm)
69 in
(175 cm)
27 in
(69 cm)
30 in
(76 cm)
78 in
(198 cm)
1.5 in
(4 cm)
79.2 in
(201 cm)
4
www.wearevita.com

2
Lay one of the posts on the ground and insert the bottom
rail and the three vertical spindles as shown aside.
Note that the longer spindle should be inthe middle of
the three.
Insert the seven horizontal spindlesas shown aside.
Continue assembly by inserting the top arched rail end
into the post and progressively into each of the vertical
spindles.
Proceed to attachthe second post to the trellis assembly
as shown below.
1
2
3
4
STEP ONE
NOTE: There are locking tabs located at the ends of the
horizontal rails. Once inserted and pushed into the routed
holes, they will lock into place.
1
2
3
4
Short Spindle
Short Spindle
Long Spindle
The London Trellis

3
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: [phone] Toll Free Fax:[phone]
STEP T WO
Secure the trellis with 8 of the provided screws at the locations shown
below. Ensure the trellis posts and rails are square to each other.
Install Screws
Push the post caps to the posts as illustrated.
Install Post Caps
The London Trellis

4
3
Move the trellis to its final location. When you are satisfied with
the locatio n,mark the positions of the posts,then move the trellis
aside and lay it carefully on it’s side. Excavate the 2 post holes
approximately 15" (38 cm) deep x 6" (15 cm) diameter. Carefully
move the trellis back into position.
Level it both vertically and horizontally into the excavated holes.
Backfill the holeswith the excavated soil.
A
B
C
Mounting Into the Ground
Trellises must be well secured in the event of high winds, etc. We
have provided two ground mounting extensions for securing the
trellis either into the ground or into a concrete footing. If
you are installing your trellis directly to the wall of your home, or on a
wood deck or concrete surface, please see your hardware store for the
appropriate galvanized bracket hardware.
STEP THREE
In sta ll the Ground Mounting Extensions
Insert the ground mounting extensions into the bottom of the
trellis posts. Secure with screws as shown aside.
STEP FOUR
Install Trellis into Ground
A
4
15” (38 cm)
Level
6“
(15 cm)
B
C
North America Toll Free Phone: [phone]
www.wearevita.com