Vital Baby NOURISH SCOOP User manual

scoop™ highchair

IMPORTANT, RETAIN FOR FUTURE REFERENCES:
READ CAREFULLY BEFORE USE.
FOR YOUR SAFETY AND HEALTH WARNING!
• Never leave the child unattended.
• Always use the safety harness.
• Falling hazard: Do not allow your child
to climb on the product.
• Do not use the product unless all components are correctly fitted and
adjusted.
• Do not use the product if any part is broken, torn or missing
• Be aware of the risk of open fires and other sources of strong heat in the
vicinity of the product.
• Be aware of the risk of tipping when your child can push its feet against a
table or any other structure.
• Do not use until the child can sit up unaided.
• Remove all packaging and keep all components out of the reach of
children when not in use.
• This product is not a toy. Strap loops can cause strangulation. Never let
children play with the chair or use it unsupervised.
• Keep children away when unfolding and folding the product to avoid
injury
• This product as a highchair is intended for children able to sit up unaided
and up to 3 years or a maximum weight of 15 kg.
• This product should only be used for the intended purpose for which it
was designed, according to the instructions enclosed. Any other use is
considered improper and therefore dangerous.
• Always hold the child securely when lifting them in or out of the chair.
Make sure that the safety harness is fastened and the table is properly
fixed in front of the child before you let go of them.
• Always adjust the safety harness and table snugly against the child to
prevent them from climbing out of the product.
• Never attempt to move the product while the child is still in the chair.
• The product should be placed on a level, horizontal floor. To avoid the risk
of the highchair tipping over, make sure that the chair’s feet can slide on
the floor.
• Do not place near open fires and other sources of strong heat.
• To avoid the risk of injury, ensure that the child is wearing – at a minimum
– a nappy/diaper or trousers when sitting in the product
• Never push down on the table or tray – doing so risks injuring the knees of
larger children

CLEANING AND CARE
• Before first and after each use, clean all parts with warm, soapy water or
a mild detergent.
• Do not use bleach, abrasives, solvents, harsh chemicals or scourers to
clean the product, this could cause damage to the product.
• Do not store or leave in direct sunlight or near a source of heat as this
could damage the product.
• Table tray is suitable for the dishwasher (max 65°C)
TECHNICAL INFORMATION
• Name: Vital Baby®NOURISH™ scoop™ highchair
• SKU: 444282
• Net weight: 4.4kg
• Age: 6 months – 3 years
• Complies to EN14988
ATTENTION
ENSURE THE HIGHCHAIR TABLE UNIT IS SECURELY IN
PLACE AT ALL TIMES.
SEE BELOW FOR REFERENCE.
Slide the table unit in to place in the chair (see figure 3). You will hear a
“click” when this is securely in place.
WARNING: If you do not hear a “click”, the table unit is not secured
properly.
FIGURE 3

ASSEMBLY INSTRUCTIONS – HIGHCHAIR
Step 1
Insert the upper front legs (9) into
the lower front legs (7), then insert
the upper rear legs (10) into the
lower rear legs (8). See figure 1.
Make sure that the pins lock into
place in the holes – you will hear a
“click” when they are secure.
Step 2
Insert the assembled legs into the
chair, ensuring that the straight
front legs slot into holes “A” and
“B” at the front of the chair, and
that the slightly curved rear legs
slot into holes “C” and “D”. See
figure 2. Make sure that the pins
lock into place in the holes – you
will hear a “click” when they are
secure.
Step 3
Slide the table unit (3) in to place
in the chair (see figure 3). You will
hear a “click” when this is securely
in place. Rotate the table to the
eating position (see “ROTATING
THE TABLE”) and slot the table
tray (4) into place.
Step 4
Slot the footrest (5) into place in
the pillar of the table. Make sure
that the pin locks into place in the
holes – you will hear a “click” when
they are secure. See figure 4.
Step 5
Thread the harness through the
slots in the chair cushion (2),
ensuring that the cushion sits snug
against the chair and no part of
the harness is trapped behind the
cushion.
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 1
ASSEMBLED
FRONT LEGS
ASSEMBLED
BACK LEGS
A
B
D
C

TRANSITIONING FROM HIGHCHAIR TO TODDLER CHAIR
Step 1
Ensure the highchair is in the
open position with the tray
pulled and rotated forward –
SEE “ROTATING THE TABLE”
and “ADJUSTING THE TABLE”.
Thenremove the footrest. Do this
by pushing the pin that’s secured
into the highchair on the back of
the pillar, while simultaneously
pulling the footrest downwards.
See figure 5.
Step 2
Push the tray release button
located on the underside of the
chair (see figure 9) and slide the
table unit out and away from the
chair. Once the table has been
removed, slot the chair cap (6)
in to place in the chair - you will
hear a “click” when it is secure.
See figure 6.
Step 3
De-thread the harness from the
chair cushion and remove the
cushion from the chair, before
removing the harness straps from
the chair.
Step 4
Remove the legs from the
highchair and disassemble.
Then,replace the lower front
legs and lower rear legs into the
highchair. The longer front legs
should be inserted into slots “A”
and “B” and the shorter back
legs should be inserted into slots
“C” and “D”. See figure 2.
FIGURE 5
FIGURE 6

ROTATING THE TABLE
The tray table can be rotated in
to 3 different positions – open,
eating and store. For how to store,
see “STORING THE HIGHCHAIR”.
To rotate the table, push the
buttons either side of the pillar
underneath the pillar (see figure
7) while simultaneously rotating
the table. You will hear a “click”
when the table is securely in
place.
ADJUSTING THE TABLE
Push the button underneath
the table (see figure 8), while
simultaneously pulling or pushing
the table in or out.
SECURING OR REMOVING
THE TABLE
Push the button located on the
underside of the chair (see figure
9) and slide the table unit out and
away from the chair.
ADJUSTING THE FOOTREST
The foot rest has 2 different levels,
adjustable by pushing the two
buttons on the rear of the foot
rest and sliding it up or down.
STORING THE HIGHCHAIR
To put the highchair in to the
storage position, first pull the
table out (see “ADJUSTING THE
TABLE”). Then, rotate the table to
the store position, before pulling
the button on the rear leg bracket
(see figure 10) and pushing the
legs in toward the front legs. You
will hear a “click” when they are
securely in place. See figure 11.
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11

COMPONENTS CHECKLIST
1. chair
2. chair cushion
3. table
4. table tray
5. footrest
6. chair cap (for use with toddler chair only)
7. lower front legs
8. lower rear legs
9. upper front legs
10. upper rear legs
1
3
4
5
2
6
7 8 9 10

www.vitalbaby.com
Made in China to Vital Baby®specifications. Vital Innovations Limited, Hatfield,
Herts, AL10 9EW, United Kingdom. Vital Baby®is a registered trademark.
NOURISH™ is a trademark. Design Rights. © Vital Innovations Ltd 2021