Vivitar JUS6000PDQ-ASST User manual

USER’S MANUAL I JUS6000PDQ-ASST
1. Press and hold the Power button for 2-3 seconds to turn the speaker On.
Wireless Speaker
2-3 SEC
PRESS & HOLD
SPECIFICATIONS
CHARGING
BLUETOOTH PAIRING
Bluetooth Range: Up to 33 feet (10 meters)
Battery Type: Polymer Lithium Ion Battery
Charging Input:
Play Time: Approximately 3-5 hours**
Charging Time: Approximately 1-2 hours
**Applicable at 50% of maximum volume. Results will be lower when
volume is higher.
1. The included USB charging cable has a Micro USB plug
and a standard USB plug.
2. Insert the cable’s standard USB plug into the USB port of a computer
or suitable USB charging adapter. Then insert the cable’s Micro USB end
into the speaker’s charging port. Charging in red light, Light o after full charge.
Micro USB
Plug USB
Plug
The Bluetooth® word mark and logos
are registered trademarks owned by
the Bluetooth SIG, Inc. and any use of
such marks by Sakar International is
under license. Other trademarks and
trade names are those of their
respective owners.
A QUICK LOOK
2. Go to the Bluetooth settings menu on your phone. Make sure that
Bluetooth is turned on. Connect to the device listed as "Wireless Speaker."
connected
Wireless Speaker
DC 5V 500 mA
Power
Charging port

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Consult the dealer or an experienced radio/TV technician for help.
1. READ ALL INSTRUCTIONS BEFORE USING YOUR SPEAKER.
2. Do not allow children to use the speaker without proper adult supervision.
3. Do not expose your speaker to excessive heat or fire.
4. Always press the buttons carefully.
5. Do not use in extremely dry environments as this can lead to static discharge during usage.
6. Do not expose your speaker to temperatures above 104°/ 40°C. Keep out of direct sunlight.
7. Do not attempt to repair this product yourself. Contact a qualified service center if your
speaker are in need of service.
8. Do not drop, puncture or expose the speaker to extreme physical force.
9. Your speaker are not intended for commercial use.
10. Do not place the speaker near objects that generate a strong magnetic field.
11. Use only the included charging cable.
12.Unplug this device when not in use for long periods of time and during lightning storms.
13. Do not pull or yank on the power cable. Always remove the cable gently from wall outlets and
the speaker’s charging port.
14. Use a soft cloth to clean your speaker. Never use rubbing alcohol or other harsh chemicals.
15. Please recycle or dispose of your speaker properly based on the laws and rules of your
16. ThedevicehasbeenevaluatedtomeetgeneralRFexposurerequirement.
municipality. Contact local recycling facilities and/or the manufacturer of your speaker for
futher information.
IMPORTANT SAFETY PRECAUTIONS
VIVITAR ONE YEAR WARRANTY
FCC STATEMENT
©2023 Sakar International
195 Carter Drive
Edison, NJ 08817
Support: 800 592 9541
www.vivitar.com
OTHER FUNCTIONS
This warranty covers the original consumer purchaser only and is not transferable.
This warranty covers products that fail to function properly UNDER NORMAL USAGE, due to defects in material or
workmanship. Your product will be repaired or replaced at no charge for parts or labor for a period of one year.
What Is Not Covered by Warranty
Damages or malfunctions not resulting from defects in material or workmanship and damages or malfunctions from other
than normal use, including but limited to, repair by unauthorized parties, tampering, modification or accident.
To Obtain Warranty Service and Troubleshooting Information:
Call 1-800-592-9541 or visit our website at www.vivitar.com.
To receive Warranty service along with the name and address of an authorized product service center, the original consumer
purchaser must contact us for problem determination and service procedures. Proof of purchase in the form of a bill of sale or
receipted invoice, evidencing that the product is within the applicable Warranty period(s), MUST be presented in order to
obtain the requested service. It is your responsibility to properly package and send any defective products along with a dated
copy of proof of purchase, a written explanation of the problem, and a valid return address to the authorized service center at
your expense. Do not include any other items or accessories with the defective product. Any products received by the
authorized service center that are not covered by warranty will be returned unrepaired.
1. Turn on two speakers, and short press power button into TWS mode
(Do not do BT pairing pls).
2. Short press twice one of the power button into tws pairing.
3. Wait for ting voice means tws pairing finish automatically.
4. Do BT pairing, then go for music playing.
5. End TWS pairing: close BT pairing firstly, short press twice power
button to end tws pairing.
TWS

FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.