Vivo BEE-V004B User manual

Two Frame Stainless Steel Honey Extractor
Scan the QR code with your mobile device or follow the link
for helpful videos and specications related to this product.
Instruction Manual
https://vivo-us.com/products/bee-v004b
SKU: BEE-V004B
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
If you do not understand these directions, or if you have any doubts about
the safety of the installation, please call a qualied technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual and do not
exceed weight capacity. We cannot be liable for damage or injury caused by
improper mounting, incorrect assembly or inappropriate use.
WARNING: IMPORTANT SAFETY INFORMATION
READ AND FOLLOW ALL SAFETY REQUIREMENTS
PREPARATION
1. Aer carefully removing the machine from the packing carton, remove
all protective lm and clean the honey extractor thoroughly with mild
soap and water BEFORE rst use.
2. The honey extractor should be placed on a dry, at stable surface.
KEEP THIS MANUAL IN A SAFE AND DRY PLACE FOR FUTURE REFERENCE
CAUTION: SHARP EDGES
PACKAGE CONTENTS
A (x1)
Drum
B (x3)
Upper Leg
C (x3)
Lower Leg
D (x1)
Handle
E (x2)
Lid
F (x1)
Honey Gate
S-A (x4)
M8x25 Hex
Head Screw
S-B (x4)
M8x20 Hex
Head Screw
S-C (x4)
M8x16 Hex
Head Screw
S-D (x10)
M8 Lock
Washer
S-F (x6)
M8 Plastic
Knob
S-G (x3)
Concrete
Anchor NOTE: Not all hardware will be used.
S-E (x10)
M8 Washer

3
STEP 1
Assemble Upper Legs (B) and Lower Legs (C) in one of the two height settings
using M8x16 Hex Head Screws (S-C) M8 Washers (S-E) and M8 Lock Washers (S-
D).
ASSEMBLY STEPS
STEP 2
Mount leg assemblies to Drum (A) using M8x25 Hex Head Screws (S-A) and M8x20
Hex Head Screws (S-B) with M8 Washers (S-E), M8 Lock Washers (S-D) and M8
Plastic Knobs (S-F).
B
C
S-C
S-D
S-B
S-E
S-D
S-F
S-E
S-A
S-E
S-D
S-F

4
STEP 3
Carefully cut the zipties securing the basket to the upper crossbar in Drum (A).
Remove the wingnuts from the top of the crossbar and carefully remove the
crossbar and basket from Drum (A).
STEP 4
Install Honey Gate (F) in Drum (A) and reinstall the basket and crossbar to Drum
(A).
A
F
A

5
STEP 5
STEP 6
Slide Handle (D) onto the sha on Drum (A). Tighten the security screw and nut
on Handle (D) to secure it in place.
Place Lids (E) on top of Drum (A).
STEP 7 (Optional)
D
A
E
A
For added security, Concrete Anchors (S-G) can be use to secure the extractor to
the oor.