Vivo CART-WB48A User manual

48” x 32” Mobile Double Sided Whiteboard
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/cart-wb48a
[email protected]om www.vivo-us.com 1-800-371-5654
SKU: CART-WB48A

2
PACKAGE CONTENTS
WARNING!
A (x1)
Board
B(x2)
Vertical Support
C(x2)
Feet
D (x1)
Base Support
E (x1)
Mid Supprt
F (x1)
Marker Tray
G (x1)
Rotation Lock
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do
not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly
or inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF CART.
• USE TIPOVER RESTRAINT OR ANCHOR CART TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
ASSEMBLY STEPS
H (x4)
Caster
I (x1)
5mm Allen Key
J(x1)
Wrench
K(x2)
Pole Cap
L (x8)
Bolt Cap
M (x12)
6x30mm Bolt
N (x4)
5x16mm Screw
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
STEP 1
Fasten casters (H) to feet (C) using the wrench (J). Install feet to vertical supports (B) using 6x25mm
bolts (M) and tighten with the 5mm Allen key (I).

3
STEP 2
STEP 3
STEP 4
CLEANING TIP: A mild dish washing liquid can be used with a so cloth to clean the surface.
Fasten mid support (E) and base support (D) to vertical supports using 6x25mm bolts (M).
Tighten with the Allen key (I). Press the bolt caps (L) into holes to cover bolts. Assemble
marker tray (F) to mid support using a 4x12 screw (N) at each end. Attach rotation lock
(G) to marker tray and mid support using 4x12 screws. Tighten all screws with a Phillips
screwdriver.
Slide board (A) into frame. Cover open ends of
vertical supports using pole caps (K).
Push the rotation lock down to release and rotate board.

Last Updated: 05/22/2019
If any parts are received damaged or defective, please contact us. We are happy to
replace parts to ensure you have a fully functioning product.
For more VIVO products, check out our website at:
www.vivo-us.com.
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
[email protected]om www.vivo-us.com 1-800-371-5654