Vivotek FD8156 User manual

1
Reset button
Microphone
Lens
Lens retention screw
MicroSD card
slot
Status LED
FD8156/8168
Quick Installation Guide
Before you begin:
You can connect the
Ethernet cable to a PC or
laptop for a live view. (See
page 5). Raise the camera
to the estimated position,
and evaluate the eld of
view by turning the mount
bracket and lens.
Shooting
direction
Loosen the retention screw
to change shooting angle.
1. The camera can only be powered by Power
over Ethernet (PoE).
2. The camera can only be installed in an
indoor environment.
NOTE:
Part no.: 625024500G

2
30mm Front mark
Ceiling Mount Procedure:
1. Attach the alignment sticker to
a preferred location, with the
Front mark facing the shooting
direction.
3. Install the mount bracket
using the self-tapping
screws.
2. Drill a 30mm cabling
hole if preferred.
4. Pass the Ethernet cable through the cabling hole or along the
wall. 5. Join the camera with the mount bracket by
sliding it along the grooves to t into place.
Mount
bracket

3
30mm
15mm
Wall Mount Procedure:
1. Attach the mount bracket to the wall-mount bracket, with
the Front mark facing the shooting direction. Note that you
should turn the bracket to aim the Front mark at the shooting
direction.
2. Attach the alignment sticker to a preferred location.
3. Mark the drill holes and drive screws into the wall. Leave
15mm of the screws off the wall surface.
4. If preferred, drill a 30mm cabling hole on the wall.

4
5. Hang the bracket onto the screws. You can then fasten the
screws to wall.
6. Connect the Ethernet cable and pass cable through the
hole. Join the camera with the bracket by sliding it along the
grooves.

5
Connect the camera to a PC or laptop. Install and use the IW2
utility to discover your camera on LAN. Double-click on the
camera entry to open a web session.
If your image appears to be out of focus, use the included focus
adjustment tool to tune the focus.
Tune the focus:
0002D1730202
00-02-D1-73-02-02 192.168.5.151 FD8168
IW2
Browser

6
Press the release button if you should need to re-install the
camera.
Carefully place the tool onto the lens, and turn clockwise or
counter-clockwise to adjust the focus.
Release button
NOTE:

7
This page is intentionally left blank.

8