VIZILOK C7FS User manual
P
?
-
8
(5
)
Scwdver
5
6
I s, Door preparans HOLE MARNG
Place the template and fold on the door edge,
check the distances and centers to drill.
Choose and mark the distance from the edge of
the door (2-3/4" [70mm] vs 2-3/8" [60mm]). It is
recommended to install locks/handles between
35"-40" (90cm-100cm) from the floor.
Determining door hang HOLES side
-
-
Carefully drill the door with
a
drill/hole-saw on the
previously marked centers: first cut the larger
2-1/8" (54mm) hole through the door and then the
smaller 15/16" (24mm) hole from the door's edge
into the center of the larger hole.
Insert the latch bolt into the
15/16" (24mm) hole and draw
the outline of the front. Chisel
out the marked area to
1/8" (3mm) depth to fit the
latch plate in step 5.
a
Insert the latch into the hole in the door edge with its
sloping side according to the direction that the door
closes. Fasten the latchplate flush to the door edge
surface with the provided screws and a #1 or #2 Phillips
screwdriver.
Attaching of exterior lock handle
Installation of interior lock handle
squa squa Scw
Stike installation
Install the exterior lock handle by inserting the posts and
the square bolt into the holes in the latch mechanism.
=
3/32"
=
3/32"
1 3/8" -2" @ 0 0 0 mp I
C
hanging Right
-
handed to Left
-
handed
:
I I =2 1/8"
Step 1 : Turn clockwise to open the front rose cover.
Step 2: Pull the rose cover out.
Step 3: Rotate the rose cover 180 degrees so the screen is centered at the bottom.
Step 4: Turn the rose cover counter-clockwise to lock it; the upside-down VACANT
should be visible.
Step 5: Rotate the assembled indicator half of lock 180 degrees and install in the door.
FOLD ON DOOR'S EDGE
DISTANCE FROM FLOOR TO CENTER OF DRILLING = 35” - 40”
