Vizmo VIZMONET RJ-2002 User manual

Vizmonet Pte Ltd
www.vizmonet.com
USER MANUAL
MODEL RJ-2002
BRAND VIZMONET
FCC ID VJA-RJ2002
IC 7382A-RJ2002
RJ-2002 is an IEEE 802.11a/n Radio Module engineered for carrier class long range high data capacity
applications. With superior TX power efficient RF design, the product supports high TX Power offering
best-in class EVM performance at higher modulation schemes. This facilitates to achieve long range
without compromising on data throughput. With well-engineered RX Design, RJ-2002 offers ultra-low
receive sensitivity to achieve long range.
TECHNICAL SPECIFICATION
RADIO MODULE –GENERAL INFO
Chipset
QCA 9550-AT4B (CPU) & AR 8033-AL1B (Ethernet PHY)
Memory
NOR Flash
NAND Flash
RAM
SPI Flash, 16MB
NAND Flash, 256 MB
DDR2, 200 MHz, 256 MB (64Mx16x2)
Operating Frequency
4942.5 MHz to 5825 MHz (Operating Channels)
Data Rate
Legacy 11a
11n HT20/HT40-1S (SISO)
11n HT20/HT40-2S (MIMO)
Data Modulation
6Mbps, 9Mbps, 12Mbps, 24Mbps, 36Mbps, 48Mbps,54Mbps
MCS0, MCS1, MCS2, MCS3, MCS4, MCS5, MCS6, MCS7
MCS8, MCS9, MCS10, MCS11, MCS12, MCS13, MCS14, MCS15
Channel Bandwidth
20 MHz/40 MHz
INTERFACE SPECIFICATIONS
Power in
Power Over Ethernet
Operating Voltage
9V to 30V
RF Antenna connector
x4 N Bulk Head Female Connector
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature Range
-40 deg C to +85 deg C
REGULATORY INFORMATION
Compliance
FCC, IC, CE

Vizmonet Pte Ltd
www.vizmonet.com
MECHANICAL SPECIFICATIONS
Federal Communications Commission Interference Statement
(FCC ID VJA-RJ2002)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference ina residentialinstallation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
oReorient or relocate the receiving antenna.
oIncrease the separation between the equipment and receiver.
oConnect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Vizmonet Pte Ltd
www.vizmonet.com
oConsult the dealer or an experienced technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 26 cm
between the radiator & your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions:
The antenna must be installed such that 26 cm is maintained between the antenna
and users, and
The transmitter module should not be used co-located with any other transmitter or
antenna
IMPORTANT NOTE:
In the event that these conditions cannot be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 26 cm may be maintained between the antenna and users.
The final end product must be labeled in a visible area with the following:

Vizmonet Pte Ltd
www.vizmonet.com
“Contains FCC ID: VJA-RJ2002 and IC: 7382A-RJ2002”
WARNING: This device has been tested with a MMCX connector and antennae as listed in the table
below. When integrated into the OEM products, these fixed antennae require professional installation,
preventing end users from replacing them with non-compliant antennae.
Antenna Installation: It is installer's responsibility to ensure that when using the authorized antennae
in the United States (or where FCC rules apply); only those antennae certified with the product are
used. The use of any antenna other than those certified with the product is expressly forbidden in
accordance to FCC rules CFR47. The installer should configure the output power level of antennas,
according to country regulations and per antenna type. Professional installation is required of
equipment with connectors to ensure compliance with health and safety issues.
Antenna information:
This radio transmitter (IC: 7382A-RJ2002) has been approved by Industry Canada to operate with the
antenna types listed below with the maximum permissible gain indicated. Antenna types not included
in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited
for use with this device.
5725MHz to 5850MHz
Trade name：RAJANT
Type : External type(Omni)
Model name：KMA-5800-6-NM
Max. Gain : 6 dBi
This modular transmitter complies with the FCC rule Part 15.209. The modular transmitter
specification is as below.
Frequency band: UNII 802.11 a, n20 (HT 20), n40 (HT40)
Modulation Type: OFDM
Frequency
Country
RED EIRP
[dBm]
FCC conduct power
[W]
4940MHz to 4990MHz
USA
-----
0.7031
5150MHz to 5250MHz
Europe, USA
22.78
0.204
5250MHz to 5350MHz
Europe, USA
22.80
0.158
5470MHz to 5725MHz
Europe, USA
29.89
0.167
5725MHz to 5850MHz
Europe, USA, Canada
34.63
0.673

Vizmonet Pte Ltd
www.vizmonet.com
OEM Installation:
This module is intended for OEM installations only. The OEM integrator is responsible for ensuring
that the end-user has no manual instructions to install, remove or modify the module.
When the module is used in OEM system, final host product should be tested to ensure compliance
with Part 15 Subpart B and the product must use a physical label stating ““Contains Transmitter
Module FCC ID: VJA-RJ2002 and IC: 7382A-RJ2002,” or “Contains FCC ID: VJA-RJ2002 and IC: 7382A-
RJ2002,” or shall use e-labelling.
Industry Canada (IC: 7382A-RJ2002)
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
This product meets the applicable Innovation, Science and Economic Development Canada technical
specifications.
CAN ICES-003 (A)/NMB-003(A)
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following
two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage
est susceptible d’en compromettre le fonctionnement.

Vizmonet Pte Ltd
www.vizmonet.com
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 26 cm
de distance entre la source de rayonnement et votre corps.
CE (Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta,
Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland,
Turkey)
IMPORTANT: Regarding indoor-only frequencies
In regions where radio frequencies are regulated by ETSI (CE), the frequency range 5170-5350 MHz is
restricted to indoor use only. Check local regulations before using these channels.
In many regions where radio frequencies are regulated by ETSI (CE), a license is required to use
channels in the frequency range 5735-5835 MHz (on models that offer these channels). Check local
regulations before using these channels.