VIZpin PDQ 6300R Series User manual

VIZPIN POWERED 6WS
INSTALLATION INSTRUCTION
FOR PDQ 6300R / 6300V SERIES EXIT DEVICE
1.PREPARETRIMFOR
INSTALLATION
• Rotate lever to proper orientation for door, install
square drive spindle into back of trim.
3.RIMDEVICE-INSTALL
CONTROLBOARD
• Install control board assembly – feed wire
through slot under circuit board.
• Secure assembly with (4) included wood/
metal screws.
• Make wire connection after control board
is installed. Push extra wire into door
cavity.
2.INSTALLTRIMANDEXIT
DEVICE
▪ Prepare door according to included
template.
▪ Install escutcheon trim onto door while
feeding wire through door.
▪ Install exit device and secure with (4)
included pan head screws.
▪ Rim Device: Install chassis/head cover.
▪ SVR Device: Skip to step 4
WIRE SLOT
VZ-9704 Rev0 – 9-7-22
LH/LHR RH/RHR LH/LHR RH/RHR
MOTOR
WIRE
For Electrical Concerns:
Email: [email protected]
www.VIZpin.com
For Electrical Concerns:
Email: [email protected]
www.VIZpin.com
For Mechanical Concerns:
Phone: [phone]
www.pdqlocks.com
For Mechanical Concerns:
Phone: [phone]
www.pdqlocks.com

4.SVRDEVICE-INSTALL
SPACER&CONTROLBOARD
• Install rod spacer block with (2) included
wood/metal screws – feed wires through
slot in block.
• Install top rod before control board.
• Install control board assembly – feed wire
through slot under circuit board and secure
assembly with (4) wood/metal screws.
• Make wire connections after control board
installed. Push extra wire into door cavity.
• Install Chassis/Head cover
VIZPIN POWERED 6WS
INSTALLATION INSTRUCTION
FOR PDQ 6300R / 6300V SERIES EXIT DEVICE
VZ-9704 Rev0 – 9-7-22
6.INSTALLBATTERIESAND
BATTERYCOVER
▪ Install batteries and battery cover with
(2) black pan head screws.
5.INSTALLBATTERYPACK
▪ Plug battery wire into control board.
▪ Install battery pack over two studs on
mounting plate and snap battery pack
onto retainers on control board
assembly.
BATTERY
PACK
BATTERY
COVER
WIRE SLOT
ROD
SPACER
BLOCK
CONTROL
BOARD
ASSEMBLY
TOP ROD
BATTERY
PLUG
BATTERY
RETAINERS