VKB-Sim Mamba w/ MCG Pro User manual
2
Kit includes:
1. 6-pin to 2-pin connector.
2. 2 copper screws.
3. 4-pin plug for Black Mamba
only.
4. Adapter PCB.
5. 4-pin connector.
6. MCG Pro with 5-pin connector.
3
Disassembling:
1. Remove the screws and take
out the base plate.
2. Disconnect X-AXIS, Y-AXIS,
WARTHOG connectors and
remove the gimble.
4
Installation:
1. Install the adapter PCB and fix
it with copper screws.
2. Connect the 4-pin connector
which is disconnected from
LEFT BOARD socket to adapter
PCB. Connect as the picture
shows on the left.
3. Take the 4-pin connector,
connect LEFT BOARD socket
and adapter PCB. Connect as
the picture shows on the right.
NOTE: Please double check 4-pin
connectors, must connect as
pictures shows.
5
4. Take the 6-pin to 2-pin
connector, connect STICK
socket and adapter PCB.
For Black Mamba, replace the
6-pin plug with 4-pin plug.
5. Install the gimble and connect
its 5-pin connector to adapter
PCB. And connect X-AXIS, Y-
AXIS connectors.
6
Assembling:
6. Arrange cables and make sure
it won’t go into any gaps.
7. Check every cables and plugs,
make sure it’s in correct
position and connect well.
7
8. Connect the connector of grip,
then install the grip and
tighten it.
9. Download VKBDevCfg
(v0.90.3.5) and firmware for
Mamba w/ MCG Pro.
For Gladiator Pro, download
Gl_MCG_MCG-Pro_v1_94_B.
NOTE: Please check the latest
firmware on our websites.
10. Load the firmware and
calibrate your stick.
11. Check your stick. If everything
is OK, install the base plate.
12. You are cleared for takeoff，
have a nice flight.
Table of contents
Other VKB-Sim Controllers manuals
