VocoPro BT-1 User manual

BT-1 User’s Guide
BT-1
BLUETOOTH
MUSIC RECEIVER
LINE
OUT
VOL
Getting Connected (For BT-1L only)
Pairing
Installation (For BT-1 only)
1. When powered, the BT-1/L will automatically be discoverable in
pairing mode (indicated by the blinking LED).
2. Go to the Bluetooth settings on your Bluetooth device and pair
the device labeled VOCOPRO. This will cause the LED to remain lit
signaling a successful pairing.
NOTE: If you are prompted for a password, use: 0000.
3. Use the volume knob to adjust volume of bluetooth audio output.
4. Enjoy your music!
1. Connect the power supply to the BT-1L and a power outlet.
2. Using the supplied 1/8” to 1/8” audio cable, connect one end to the audio output on the
BT-1, connect the other end to your powered speaker or audio system.
3. Install the antenna by aligning it to the center of the antenna input and turn clockwise.
1. Remove the expansion port cover plate from your compatible host unit.
2. Find the 6-pin cable and connect its connector to the 6-pin connector on the back of the BT-1.
3. Slide the BT-1 into the port and secure with the screws.
4. Install the antenna by aligning it to the center of the antenna input and turn clockwise.
1
1
Antenna
Connector
4
2 3
32
Antenna
Connector
NOTE: Do not connect 6-pin
connector and 5V power
adapter simultaneously.

BT-1
BLUETOOTH MUSIC RECEIVER
BT-1
BLUETOOTH MUSIC RECEIVER
BT-1 User’s Guide
© VocoPro 2013
v1.0404
www.vocopro.com
OWNER’S MANUAL
Troubleshooting
If you experience performance issues with the BT-1/L, perform
the following:
1. Make sure the BT-1/L is still paired.
This can be verified by checking the LED.
• Solid LED: Paired
• Blinking LED: Not paired
If need be, repeat the process to pair your Bluetooth device.
2. Make sure you are within operating range.
The operating range is approximately 30 ft. If you are in excess
of 30 ft from the BT-1/L, the signal may cut-out or drop. Also
try and limit any obstructions to line of sight.
3. Check the volume levels.
On the BT-1/L, check the VOLUME knob to make sure it is at a
sufficient level. Check the volume setting for the sound system.
Lastly, check the sound settings on your Bluetooth device.
Specifications
•Bluetooth: Version 3
•Frequency Band 2.402GHz~2.480GHz ISM Band
• Audio input: Bluetooth
• Audio output: 1/8” mini-jack
• Power - 5VDC 200 mA
6-Pin Connector