Voltex VOLT User manual
Power Supply
Operating
Temperature
Relative
Humidity
230V AC,50 Hz, Approx 4VA
0°C To 55°C
Up to 95% RH Non Condensing
Model
Size (mm)
Display
Panel Cutout
Input Voltage
96(H) X 96 (W) X 45 (D) mm
3 Digit/Line 7 seg 0.56”,red LED Display
92 X 92 mm
VOLT
50 to 500V AC, CAT III
Protection
Level
(As per request)
IP-65 (Front side) As per IS/IEC 60529 : 2001
www.voltexcontrols.com
Page - 1VOLT
Connection Diagram
OPERATING MANUAL
3 Phase Panel Meter
VOLT
Technical Specification
LN
12347 8 9 10
56
System 3 Ph-3W:
Accuracy Class:1.0
Range
Voltage: 50 To 500V AC, CAT III
VRVYVB
230V AC
50Hz, 4VA
!
VOLT
VOLT
www.voltexcontrols.com
Page - 2
All safety related codifications, symbols and instructions that appear in this operating manual
or on the equipment must be strictly followed to ensure the safety of the operating personnel as
well as the instrument.
If all the equipment is not handled in a manner specified by the manufacturer, it might impair the
protection provided by the equipment .
Product improvement and upgrade is a constant procedure. So for more updated operating information and support,
=> Read complete instructions prior to installation and operation of the unit.
WARNING : Risk of electric shock.
3) Cable used for connection to power source, must have a cross section of 1mm or greater. These wires
should have insulations capacity made of at least 1.5kV.
2) To reduce electro magnetic interference, use wire with adequate rating and twists of the same of
equal size shall be made with shortest connection.
4) When extending the thermocouple lead wires, always use thermocouple compensation wires for wiring
for the RTD type, use a wiring material with a small lead resistance (5Ω max per line)and no resistance
differentials among three wires should be present.
1) To prevent the risk of electric shock power supply to the equipment must be kept OFF while doing the
wiring arrangement. Do not touch the terminals while power is being supplied.
5) A better anti-noise effect can be expected by using standard power supply cable for
the instrument.
Warning Guidelines
Mechanical Installation
Safety Precautions
1) Prepare the panel cutout with proper dimensions as show above.
2) Fit the unit into the panel with the help of clamp given.
3) The equipment in its installed state must not come in close proximity to any heating source,
caustic vapors, oils steam, or other unwanted process by products.
4) Use the specified size of crimp terminal (M3.5 screws) to wire the terminal block. Tightening the
screws on the terminal block using the tightening torque of the range of 1.2 N.m.
5) Do not connect anything to unused terminals.
2
A
B
C
D
EF
MODEL A
96mm 96mm 92mm 92mm 3mm 42mm
BC
D E
F
DIMENSIONS
136mm - 5.35 inches
120mm - 4.72 inches
VOLT
Table of contents
Other Voltex Measuring Instrument manuals
