Vroom 18 User manual

Release
Tab
Release
Tab
Vroom18 Cabinet Installation
2.
Locate
cardboard
Template
inside the
cabinet.
4.
Remove
the
cardboard
template.
5.
Install the Vroom
in the mounting
bracket by
pushing it into
place as shown.
It will snap in
place when
installed
correctly.
6.
Connect the
vacuum tubing
to the Vroom’s
connector on the
back as shown.
Do NOT glue,
press fit only.
If you require additional information on installation, please visit: www.VroomYourRoom.com
H-P Products, Inc. 512 W. Gorgas Street, Louisville, OH 44641
04-12 P/N 9583
1. Before installing, remove bracket from the bottom of the Vroom by inserting a flat blade
screwdriver into the release tabs located on each side of the mounting bracket as shown.
3.
Place
mounting
bracket in
template.
Secure
with 5
screws
as shown.
For service reasons,
do NOT glue this
connection.
7.
Connect the low voltage wires
on the back of the unit.

If you require additional information on installation, please visit: www.VroomYourRoom.com
H-P Products, Inc. 512 W. Gorgas Street, Louisville, OH 44641
Using Your New Vroom18
The rounded edge
of the handle
means you can
vacuum without
an attachment.
4. Optional Accessory Usage
OR
Push wand
button to
adjust
wand
length.
5. When
Finished
Flip up the
hose lock
when
finished.
2. Lock the Hose
Pull out as
much hose as
you want.
Then flip the
Hose Lock down
(as shown) to
hold it in place.
6. Retract the Hose
Cover the
handle end
with your
hand.
The Vroom
hose retracts
automatically.
INCLUDED:
Vroom
Vroom Base
Installation
Components
and Hardware
(not shown)
3. Vacuum with the Handle
Place the Handle
inside the green
knob and lower it
into the storage
position as shown.
Vroom turns off
automatically.
7. Store the Handle
Slip tool or wand securely onto end of
hose handle.
04-12 P/N 9583
1. Turn It On
Just lift the
handle until
the Vroom
clicks on.
Then pull out
the handle.