SWITCHING THE TRIMMER HEADS
1. Ensure the trimmer is switched off before changing the
attachment heads.
2. To remove a trimming head, twist the top section of the trimmer
(the trimming head attachment) to the right, until the line ‘I’ on
the base of the trimming head attachment is positioned above
the line ‘É ’ on the top of the trimmer, then pull straight off.
3. To attach a trimming head, position the line ‘I’ on the base of the
trimming head attachment above the line ‘É ’ on the top of the
trimmer. Then simply twist the head to the left until it clicks into
place. The line ‘I’ should be positioned above the ‘o’ mark on the
top of the trimmer.
USING THE TRIMMER
1. To use the trimmer, simply slide the on/off switch upwards, so
that the ‘I-ON’ marking is visible.
2. After using the trimmer, slide the on/off switch down, so that the
‘O-OFF’ marking is visible.
TO TRIM HAIR FROM THE NOSE/EARS
1. Select the rotary blade attachment and switch the unit on.
2. Gently insert the trimmer into your nostril or ear canal to trim
unwanted hair.
3. Move the trimmer in and out of the opening of the nostril or ear
canal using a circular motion, taking care not to come too close
to the border of the nostril or ear.
NB – Always turn the trimmer on BEFORE you insert into your nostril
or ear canal to avoid painfully snagging hairs.
Never insert the trimmer more than 5-6mm into your nose or ear.
Using any deeper than this can cause injury.
