4. To change the name of the wireless network, highlight the SSID,
which is currently “VTel Wireless”, and change it to your desired
network name. To change the network name without changing the
password, click “Apply” in the bottom right hand corner. If you are
connected wirelessly to the R565, you will be disconnected and must
reconnect to the network which should be listed under its new name.
5. To change your wireless network password, click the “Wireless
Security” tab and change the “Key” to your desired password.
9. In the “Network security key” eld, en-
ter your new password and click OK. OR, if
you changed your security settings to “No
Encryption”, change “Security Type” to “No
authentication (Open)”. You should then
be able to reconnect to the device.
7. If you changed ONLY the password of your
network, and are attempting to reconnect from
a Windows computer, you will need to change
the saved password stored on your computer
by following steps 8 and 9.
8. In the list of wireless networks, right click
VTel Wireless (or the new name you’ve given
your network) and click “Properties”.
8
6. Click “Apply” in the bottom right hand corner of the screen. If you are
connected wirelessly to the R565, you will be disconnected from the
device until you re-connect to the network using your new password.
