©2014 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
2
AIR COMPRESSOR OPERATION:
Caution: never leave compressor unattended while in use
NOTE: If your vehicle's tire is completely deflated, it is possible that the seal
between the tire and the rim could be broken allowing air to leak out when trying
to inflate. This usually only happens with completely flat tires. In the event that this
situation occurs, you will have to jack up your car prior to tire inflation.
1. Pull out hose from compartment. Place nozzle over valve stem of tire with
thumb lever in the vertical position.
2. Push thumb lever down firmly (into horizontal position) and lock into place.
3. Turn compressor’s switch on and monitor pressure using the built-in
pressure gauge. Do not overinflate products beyond the manufacturer’s
recommendations.
4. When recommended tire pressure is reached, turn off the air compressor
and disconnect the hose.
• For inflating other items, select the appropriate adaptor and insert into the
hose nozzle.
• For athletic balls, moisten needle before inserting it into the ball valve.
• For other inflatable equipment, the nozzle should be inserted into valve and
held tightly to ensure a good seal.
WORK LIGHT:
The 3-in-1 Easy Air Compressor comes with a built-in adjustable angle work light.
Once the 3-in-1 Easy Air Compressor is connected to a 12V power outlet, toggle
the switch to the “||” position for easy use.
CHANGING THE LIGHT BULB:
1. Unscrew ring from the front of light in a counter-clockwise motion.
2. Unscrew bulb and replace with a new one.
3. Replace ring and lens onto the unit by turning it clockwise.
