Wagner Meters Rapid RH 5.0 User manual
TABLE OF CONTENTS
Introduction ..................................................................................................... 2
Preparing........................................................................................................... 3
Initial Charging ............................................................................................... 3
Inspection Prior to Recharging................................................................ 5
Recharging ........................................................................................................ 6
2
INTRODUCTION
The EasyCare CalCheck®units contain a saltwater solution that
emits a known 75% RH range. This allows a user to check their
sensors as needed.
The EasyCare CalCheck®
Units can easily be recharged by the user using the included
pipette and some water.
A note on nomenclature: The EasyCare CalCheck®units consist
chambers. The word unit
chambers attached together.
3
PREPARING
• Tweezers (optional)
• EasyCare CalCheck® units
• Pipettes
• Container of water
INITIAL CHARGING
Remove the EasyCare
CalCheck®
shipping tube.
and separate the two chambers
by pulling them apart.
Note: The chambers are press-
4
Fill the included pipette up
to the limit line with water.
The pipette now contains one shot
the bottom chamber. Repeat
water to the bottom chamber.
Reconnect your EasyCare
CalCheck®chambers together and
cap with a red rubber cap. When
connecting the top and bottom
mind the chambers will need to be
necessary to apply just enough
Limit Line
5
INSPECTION PRIOR TO RECHARGING
CalCheck®chambers will dehydrate
and cease to provide a known 75%
RH range. They will need to be
they will need to be inspected.
remove and inspect chamber.
and an accurate reading to be procured.
reading to be procured.
please read the
sensors.
6
®
RECHARGING
in the “Inspection Prior to
you may recharge your EasyCare
CalCheck®
the procedure outlined in the
“Initial Charging” section.
visit RapidRH.com
Table of contents
