Wahsega Carina PBX Assembly instructions

Carina PBX
Installer’s Guide
Getting Started
This step-by-step guide will help you install your
Wahsega Carina PBX.

Carina PBX Installation Guide Page 2 11.11.2020
What’s in the Box
(1) Carina PBX
(1) 2-Pin male connector
(1) 6-Pin male connector
(1) 8-Pin male connector
(1) Ferrite cable clamp

Carina PBX Installation Guide Page 3 11.11.2020
What You Will Need
PoE power
Power-over-Ethernet (PoE 802.3af) switch
Network cable (Cat 5e or Cat 6)

Carina PBX Installation Guide Page 4 11.11.2020
Wiring
Power
Option A: To use Power-over-Ethernet (POE 802.3af), route a Cat 5e or
Cat 6 Ethernet cable from a PoE switch or injector to the LAN port.
Option B: Alternately, use the included 2-pin male connector to
connect +9-16VDC and Ground wires for power. Use standard
(unpowered) Ethernet for data.
NOTE: Use either POE or 9-16V for power. DO NOT USE BOTH.
Status
The status LED will increase in brightness as the Carina PBX is powering
up and will remain steadily lit when the unit is successfully powered.
Status
LED
Ethernet or POE
If using Power Option A = POE 802.3af
If using Power Option B = Ethernet
Do Not
Use
Power
Option B
Reset

Carina PBX Installation Guide Page 5 11.11.2020
Dimensions
Front
Rear

Carina PBX Installation Guide Page 6 11.11.2020
Side

Carina PBX Installation Guide Page 7 11.11.2020
Standards Compliant
This product is designed and manufactured in the USA.
ROHS compliant
Temperature rating -40C to +60C.

Carina PBX Installation Guide Page 8 11.11.2020
Carina PBX
WL-PBX-CAR
Installation Guide