walkntalk PWT-MAGMOUNT User manual

– 2 YEAR WARRANTY
WalknTalk will replace the faulty product at no cost to the
consumer. The warranty does not extend to any
consequential damages or cost that may be incurred and
is valid for 24 months from date of purchase. The
consumer must return the faulty product to the retail
store it was purchased from together with proof of
purchase.
The warranty is provided by:
Pacific Optics (in Australia)
18 Taree St, Burleigh Heads, QLD 4220
Telephone: [phone]
Email: [email protected]
Signature Marketing NZ Ltd (in New Zealand)
25a Triton Drive, Rosedale, Auckland 0632
Telephone (NZ): [phone]
Email (NZ): [email protected]
The benefits to the consumer under this warranty are in
addition to other rights and remedies of the consumer
under Australian laws in relation to the goods to which
the warranty relates. Our goods come with guarantees
that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for
major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure
does not amount to a major failure.
Quick Start Guide
What’s included:
i
1a. Install for Dash Mount usage
Find a suitable location in your vehicle where you can
attach the Dash Mount that won’t obstruct your
visibility of the road. The surface should be
non-porous and thoroughly cleaned for the mount to
properly adhere.
Remove the 3M adhesive backing
from the Dash Mount and press
firmly to secure it to your vehicle.
Wait at least 15 minutes for the
adhesive to hold before
continuing with the installation.
PWT-MAGMOUNT
Magnetic
Phone
Mount
Front

For the most up-to-date assistance, please scan this
QR Code to download the full User Manual before
using this product.
3 Download user manual
.
Stay Connected
@walkntalk_ walkntalk.com.au@walkntalkau
1b. Install for Air Vent usage
Find a suitable air vent in your vehicle where you can
attach the Vent Mount that won’t obstruct your
visibility of the road.
Rotate the knurled body of the Vent Mount to extend
the securing hook. Latch the securing hook over a
vane in your chosen air vent. Rotate the knurled knob
in the opposite direction to withdraw the securing
hook until the Vent Mount is secured in position.
2. Finish the installation
Unscrew the ring from the back of the magnetic
phone holder. Push the ball on your chosen (dash or
vent) mount through the ring and into the concave
connector on the back of the magnetic phone holder.
Tighten the ring to the desired position.
Attach the Metal Ring Sticker
Remove the 3M adhesive backing and attach the metal
ring sticker to the outside of your phone case - or
directly on the back of your
phone if you don’t use a case.
If your phone supports wireless
charging, make sure to centre
the metal ring sticker on your
phone so it doesn’t interfere
with wireless charging.
Note for iPhone users: If you’re
using a MagSafe compatible
phone case, then you’re good to
go and won’t need to use the
metal ring sticker.
iPhone and MagSafe are trademarks of Apple Inc., registered in the U.S. and other countries
and regions.
Back