Waring PB Series User manual

PB/MB Series
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
Blenders
Kitchen Classics
by

TABLE OF CONTENTS
Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Important UK Wiring Instructions . . . . . . . . . . . . . . . . . . . .3
Important Hot Blending Instructions . . . . . . . . . . . . . . . . . .3
Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
How To Clean Containers With Nonremovable Blades . . .5
How To Clean Unit Base . . . . . . . . . . . . . . . . . . . . . . . . . .5
IMPORTANT: Always unplug the Waring®Blender from
outlet when disassembling and assembling.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following.
1. READ ALL INSTRUCTIONS:
2. To protect against risk of electrical shock, do not put
appliance in water or other liquid.
3. Close supervision is necessary when any appliance
is used by or near children.
4. Unplug from outlet when not in use, before putting on
or taking off parts, and before cleaning.
5. Avoid contacting moving parts.
6. Do not operate the Waring®Blender or any other
electrical equipment with a damaged cord or plug, or
after the unit malfunctions, or is dropped or damaged
in any manner. Return it to the nearest authorized
service facility for examination, repair, or adjustment.
7. The use of attachments, including canning jars, not
recommended or sold by Waring may cause fire,
electric shock, or injury.
8. Do not use outdoors.
1

9. Do not let cord hang over edge of table or counter,
or touch hot surfaces.
10. Keep hands and utensils out of jar while blending
to prevent the possibility of severe personal injury
and/or damage to the blender. A rubber spatula may
be used, but must be used only when the blender is
not running.
11. Blades are sharp. Handle carefully.
12. To avoid injury, never place blade assembly on the
base without container properly attached.
13. Always operate blender with cover in place.
14. When blending hot liquids, remove center piece of two
piece cover. Limit amount of material processed to one
cup (8 oz.). Always begin processing at the lowest
speed setting. Keep hands and other exposed skin
away from the lid opening to prevent possible burns.
See Hot Blending instructions.
15. Screw on container bottom firmly. Injury can result if
moving blades accidentally become exposed.
16. Do not leave blender unattended while it is running.
SAVE THESE INSTRUCTIONS
WARRANTY
2
For Waring®products sold outside of the U.S. and Canada,
the warranty is the responsibility of the local importer or
distributor. This warranty may vary according to local
regulations.
WARNING: This warranty is VOID if appliance is used on
Direct Current (D.C.).

3
IMPORTANT UK WIRING INSTRUCTIONS
This appliance is supplied with a fitted plug; however, for
your information, should you wish to change the plug, the
wires in the mains lead of the appliance are colored in
accordance with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
Warning: The severed plug should be disposed of to avoid
apossible shock hazard and should never be inserted into
a13A socket. As the colors of the mains lead of this
appliance may not correspond to the colored markings iden-
tifying the terminals in your plug, proceed as follow: the wire
which is colored Green & Yellow must be connected to the
terminal in the plug which is marked with the letter E or by
the earth symbol or colored Green or Green & Yellow.
The wire which is colored Blue must be connected to the
terminal which is marked with the letter N or colored Black
or Blue. The wire which is colored Brown must be connected
to the terminal which is marked with the letter I, or colored
Red or Brown.
Note: If the terminals of the plug are unmarked or if you are
in any doubt, consult a qualified electrician. If a BS1563
Fused Plug is used, this must be fitted with the correct
amperage fuse - 3Amp fuse.
IMPORTANT: HOT BLENDING INSTRUCTIONS
Tominimize possibility of scalding when blending hot
ingredients, the following precautions and procedures must
be observed:
1. Limit amount of material processed to one cup (8 oz.)
(0.236 liters).
2. Completely remove the lid insert of the two piece
container lid before starting motor.(This will allow

venting of the rapidly heated and expanding air
present inside container when blender is running.)
3. Start blending on low speed.
4. While blender is running, up to 11⁄2cups (0.354 liters) of
additional liquid can be added. Pour liquid slowly
through the opening in the lid.
OPERATING INSTRUCTIONS
1. When placing the container on the unit base, make sure
that the unit is turned 0 “OFF” and is at a complete stop.
Do not put the container on or take it offwhile the unit is
running. Doing so may damage the drive shaft or blade
assembly. For best results, do not fill container above
3cup level.
2. Be sure the switch is in the 0 “OFF” position and plug
the blender into a convenient outlet.
3. The Waring®Blender is ideal for blending ice drinks.
A hint when mixing ice drinks: keep the blades in the
container covered with liquid, turn the unit on, remove
the lid insert on top of the jar lid, and feed the ice cubes
slowly into the jar.NOTE: Never use containers other
than Waring®Blender containers with your Waring unit.
4. Put ingredients into container,then put on cover.Always
add liquid ingredients first, unless otherwise specified in
recipe. Always hold container with one hand while
blending.
5. CAUTION: Toavoid damage to your blender,do not run
the blender if the blades become blocked or jammed
during use. Turn the blender 0 “OFF” immediately,
remove the container from the blender base and dis-
lodge the material that is blocking or jamming the blade.
4

HOW TO CLEAN CONTAINERS WITH
NONREMOVABLE BLADES
1. Remove the container from the unit base. Remove the
lid. Add a cup of cleaning solution, made by adding a
few drops of dishwashing detergent to 1 cup of cool
water,to the container. Scrub and flush out the interior of
the container and the lid to dislodge and remove as
much residue as possible. Empty the container.
2. Add more cleaning solution. Put lid on container, place
container on unit base, and run on high speed for
two minutes.
3. Empty the container and repeat as above, using clean
rinse water in place of cleaning solution. Empty, rinse
and dry, prior to storing unit.
4. Wash and rinse container prior to initial use, and
immediately after each use.
HOW TO CLEAN UNIT BASE
1. Toclean the unit base, unplug the power cord.
Wipe the exterior surfaces with a soft cloth or sponge
dampened with cleaning solution. Rinse with clean
water. Do not immerse the base in cleaning solution or
water. Wipe the base with dry towel.
For after sales service in the UK and the Republic of Ireland,
please contact:
New Classics Ltd.
14 Market Place
Hatfield, Herts. AL10 OLN
Tel. [phone]
5

RV01 0406 027123
Waring Consumer Products Division of Conair Corporation
150 Milford Road
East Windsor, NJ 08520
www.waringproducts.com
Printed in USA
PB/MB IB