Warmlite WL46021 Mounting instructions

2000W
COMPACT STOVE FIRE
MODEL WL46021
YOUR SAFETY &
INSTRUCTION MANUAL
PLEASE READ CAREFULLY
www.warmlite.co
This product is only suitable for well insulated spaces or occasional use.

2
CUSTOMER SUPPORT TEAM: [phone]
TECHNICAL DATA
Description: Compact Stove Fire
Model: WL46021
Rated Voltage: 220 - 240V
Frequency: ~ 50/60Hz
Power consumption: 1800-2000W
DOCUMENTATION
We declare that this product conforms to the following product legislation in accordance with the
following directive(s):
2014/30/EU Electromagnetic Compatibility Directive.
2014/35/EU Low Voltage Directive.
2011/65/EU Restriction of Hazardous Substances Directive.
2009/125/EC Eco-Design of Energy Related Products.
RK Wholesale LTD Quality Assurance, United Kingdom
WARRANTY
This product is guaranteed for 12 months from the date of original purchase. If any defect arises due
to faulty materials of workmanship, the faulty products must be returned to the place of purchase.
Refund or replacement is at the discretion of the retailer.
The following conditions apply:
• The product must be returned to the retailer with proof of purchase.
• The product must be installed and used in accordance with the instructions contained in this
instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• RK Wholesale LTD has limited liability for incidental or consequential loss or damage.
• This guarantee is only Valid in the UK and Eire Only.
An extended warranty is available for this appliance.
See back page for details.

3
www.warmlite.co
6 WIRING SAFETY FOR UK USE ONLY
IMPORTANT
As the colours in the
mains lead of this
appliance may not
correspond with the
coloured markings
identifying the terminals
in your plug, please
proceed as follows:
The wires in the mains lead are coloured in
accordance with the following code:
Blue neutral [N] Brown live [L]
Green/Yellow [EARTH]
Plug Fitting Details (Where Applicable).
The wire coloured blue is the neutral and must be
connected to the terminal marked [N] or coloured
black.
The wire coloured brown is the live wire and
must be connected to the terminal marked [L] or
coloured red.
The wire coloured green/yellow must be
connected to the terminal marked with the letter
[E] or marked .
On no account must either the brown or the blue
wire be connected to the [EARTH] terminal .
Always ensure that the cord grip is fastened
correctly.
The plug must be tted with a fuse of the same
rating already tted and conforming to BS 1362
and be ASTA approved.
If in doubt consult a qualied electrician who will
be pleased to do this for you.
Non-Rewireable Mains Plug
If your appliance is supplied with a non-
rewireable plug tted to the mains lead and
should the fuse need replacing, you must use an
ASTA approved one (conforming to BS 1362 of
the same rating).
If in doubt, consult a qualied electrician who will
be pleased to do this for you.
If you need to remove the plug – disconnect it
from the mains – and then cut it o of the mains
lead and immediately dispose of it in a safe
manner. Never attempt to reuse the plug or insert
it into a socket outlet as there is a danger of an
electric shock.
WARNING:
This Appliance MUST be Earthed
FUSE

4
CUSTOMER SUPPORT TEAM: [phone]
PRODUCT SAFETY
When using any electrical appliance, basic safety precautions should
always be followed including the following:
• Check that the voltage of the
main circuit corresponds with
the rating of the appliance
before operating.
• Please ensure that the appliance
is used on a stable, level, and
heat resistant surface.
• DO NOT immerse cords, plugs
or any part of the appliance in
water or any other liquid.
• DO NOT leave the appliance
unattended while it is operating.
• Close supervision is necessary
when any appliance is used by
or near children or pets.
• This appliance can be used by
children above 8 years old and
persons with reduced physical,
sensory or mental capabilities
or lack of experience and
knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• Children shall not play with the
appliance.
• Children should not maintain
or clean the appliance unless
supervised.
• Switch o at the wall socket
then remove the plug from
the socket when not in use or
before cleaning.
• If the supply cord or appliance
is damaged, stop using the
appliance immediately and seek
advice from the manufacturer
or its service agent or a similarly
qualied person.
• DO NOT let the cord hang over
the edge of a table or counter or
let it come into contact with any
hot surfaces.
• The use of accessory
attachments is not
recommended by the appliance
manufacturer apart from those
supplied with this product. DO
NOT use extension cords with
the appliance.
• DO NOT pull the plug out by the
cord as this may damage the
plug and/or the cable.
• DO NOT use this product for
anything other than its intended
use.
• This appliance is for household
use only.
• DO NOT carry the appliance by
the power cord.
• DO NOT use the appliance
outdoors.

5
www.warmlite.co
• Always ensure that the heater is
placed on a rm level surface.
Ensure that the heater is not
positioned close to curtains,
furniture or any combustible
materials as this could create a
re hazard.
• The heater must not be located
immediately below a mains
socket outlet.
• This product is only suitable
for well-insulated spaces and
occasional use.
• DO NOT cover the heater as this
may lead to a re risk.
• DO NOT obstruct any of the
openings of the heater especially
the heat outlet at the bottom of
the heater.
• DO NOT insert any object
through any openings on the
heater.
• DO NOT use the heater in
areas where ammable liquids
are stored or where ammable
fumes may be present.
• DO NOT operate the heater on
a timer or leave on overnight.
• When not being used, please
unplug the heater from the
mains socket.
• Keep the mains lead away from
the hot body of the heater and
ensure that it is not pulled tight
between the socket and the
heater.
• DO NOT use the heater in the
immediate surroundings of a
bath, a shower, a swimming
pool or similar indoor locations.
• DO NOT use or place the
appliance on carpet. Always
place the heater on a at, stable
heat-resistant surface.
• In order to avoid a hazard due
to inadvertent resetting of the
thermal cut-out, this appliance
must not be supplied through an
external switching device, such
as a timer, or connected to a
circuit that is regularly switched
on and o by the utility.
• WARNING: This heater is not
equipped with a device to
control the room temperature.
DO NOT use this heater in small
rooms when they are occupied
by persons not capable of
leaving the room on their own,
unless constant supervision is
provided.

6
CUSTOMER SUPPORT TEAM: [phone]
• CAUTION – Some parts of this
product can become very hot
and cause burns. Particular
attention has to be given where
children and vulnerable people
when around the appliance.
• DO NOT use this appliance if it
is dropped or damaged in any
way.
• WARNING! This appliance
should only be repaired by the
manufacturer or a qualied
service repair person.
• WARNING! DO NOT use the
appliance if water damage has
occurred, if the appliance body
has been damaged, the power
cord has been damaged or
broken, if the power cord is hot
to the touch, if the unit smokes
or smells like smoke.
Note: When the heat function is
used for the rst time, a slight
odour may be present. This is
normal and may occur again if
the appliance is not used for a
long period of time.
• Always unplug the heater and
allow it to cool before moving it
from one location to another.
• DO NOT attempt to dismantle
or repair any part of the heater.
This should only be done by a
qualied service agent.
• In the unlikely event the
appliance develops a fault,
stop using it immediately and
seek advice from the Customer
Support Team.
HIGH VOLTAGE HOT SURFACE DO NOT COVER

7
www.warmlite.co
WHAT’S IN THE BOX
Instruction Manual
Compact Stove Fire
4 X Legs
12 X Screws
1. Temperature Controls
2. Glowing Eect Glass Panel
3. Hot Air Vent
4. Thermostat Control
5. On/O Switch
6. 1000W Switch
7. 2000W Switch
BEFORE YOUR FIRST USE:
1. Remove your appliance from the packaging.
2. Keep the front of the appliance through which the heat is radiated at least one meter away from
furniture, curtains and other ammable objects at all times.
3. Ensure there is a grounded socket nearby (back of the appliance).
4. Never use an extension lead. The main cable must remain at the back of the appliance and
must not be in contact with any hot elements.
5. Your appliance is now ready for normal use.
Dispose of the packaging in a responsible manner.
1
4
5
6
7
2
3

8
CUSTOMER SUPPORT TEAM: [phone]
ATTACHING THE LEGS
1. Turn product on its side to start attaching
legs.
2. Place a leg on each corner and use 3
screws for each leg.
3. Tighten the screws clockwise until tight on
each leg.
4. Turn the unit back up to standing position
making sure it is stable.
5. Place the unit in the required location and
plug in, it is now ready for use.
NOTE: The drawing below is for illustration
purposes only, your product may be slightly
dierent in looks but the operations are the
same.
CONTROL PANEL
Thermostat control dial – Adjust to maintain
room temperature
Power/Flame switch – Switches both Flame
eect and Power On/O
1000W Heat Selection – Press “-” for 1000W
2000W Heat Selection – Press “-” and “=” at
the same time for 2000W heating. The higher
heating selection cannot be activated without
rst activating the 1000W setting.
Flame Switch – Switches ame eect and
power ON/OFF.
USING YOUR APPLIANCE
1. Plug the heater into the mains socket and
switch the socket on.
2. The heater controls are located on left
hand side of the appliance.
3. Switch the re on by pushing the ON/OFF
switch to the ‘I’ position.
4. To select the heat level, you can choose
between two settings: 1000W or 2000W
5. Push switch ‘I’ to the ON position for
1000W
6. Push both switches ‘I’ and ‘II’ to the ON
position for 2000W.
7. To turn o, push all the switches to the
OFF positions.
OVERHEATING SAFETY DEVICE
If the heater stops working, turn the heater o
and visually inspect for any blockage of the
inlet or outlet. Disconnect the plug and wait at
least 10 minutes for the protection system to
reset before attempting to restart the heater.
If the safety device still switches the heater o
and the heater fails to operate, take the heater
to your nearest service centre for examination
or repair.
Attention! Before restarting the heater, the plug
must be disconnected for at least 10 minutes.
Legs Fitting Screws

9
www.warmlite.co
CLEANING AND CARE
• Before cleaning always switch o the re
and remove the plug from the electrical
socket.
• Ensure that the unit is cool enough to
work on.
• To remove the dust, wipe the appliance
with a dry cloth.
• To keep the heater clean, the outer
shell may be cleaned with a soft, damp
cloth. You may use a mild detergent if
necessary. After cleaning, dry the unit with
a soft cloth.
• CAUTION! DO NOT let liquid enter the
heater. This may cause damage or
deterioration to the heater’s surface.
• WARNING! DO NOT immerse the heater
in water or any other liquid.
• Never use abrasive powders or solvents.
• If the heater shows any signs of wear or
damage disconnect immediately from
the mains supply, do NOT use it – have it
checked by a suitably qualied person.
TROUBLE SHOOTING
Problem Solution
The heater
will not turn
on.
Make sure the appliance
is plugged into the mains
and that it is switched on. If
plugged in, make sure the
Power button is in the On
position.
No re eect
light.
Check with the manufacturer
or a qualied service person
for repair.
DISPOSAL OF THE UNIT
Appliances bearing the symbol shown here
may not be disposed of in domestic rubbish.
You are required to dispose of old electrical
and electronic appliances like this separately.
Please visit www.recycle-more.co.uk or
www.recyclenow.co.uk
for access to information about the recycling
of electrical items.
Please visit www.weeeireland.ie for access to
information about the recycling of electrical
items purchased in Ireland.
The WEEE directive, introduced in August
2006, states that all electrical items must be
recycled, rather than taken to landll.
Please arrange to take this appliance to your
local Civic Amenity site for recycling, once it
has reached the end of its life.
WARNING:
DO NOT IMMERSE ANY ELECTRICAL PART
OF THE APPLIANCE IN WATER SUCH AS
MOTOR UNITS OR PLUGS.
PLEASE SEE CLEANING SECTION FOR
FURTHER INSTRUCTIONS.

10
CUSTOMER SUPPORT TEAM: [phone]
Model Identier(s): WL46021
Item Symbol Valve Unit Item Unit
Heat Output Type of heat input for electric storage, local space
heaters only (select one)
Nominal heat
output Pnom 1,8- 2,0 kW Manual heat charge with integrated thermostat No
Minimum heat
output (indicative) Pmin N/A kW Manual heat charge control with room and/or outdoor temperature feedback No
Maximum
continuous heat
output
Pmax, c N/A kW Electronic heat charge control with room
and/or outdoor temperature feedback No
Auxiliary electricity
consumption Fan assisted heat output No
At nominal heat
output elmax N/A kW Type of heat output/room temperature control (select one)
At minimum heat
output elmin N/A kW Single stage heat output and no room temperature control No
In standby mode eISB N/A kW Two or more manual stages, no room
temperature control No
With mechanic thermostat room temperature
control Yes
With electronic room temperature control No
Electronic room temperature control plus day
timer No
Electronic room temperature control plus
week timer No
Other control options (multiple selections possible)
Room temperature control with presence
detection No
Room temperature control with open
window detection No
With distance control option No
With adaptive start control No
With working time limitation No
With black bulb sensor No
Contact Details: Imported by RK Wholesale LTD., Berryhill Road, Stoke-on-Trent ST4 2NL