Wasserstein Smart Water Leak Detector User manual
Smart Water Leak Detector
USER MANUAL
In the Box
Parts
Page 1
1 x water sensor 1 x probe cable 1 x holder
1 x 3 volt battery
(in water sensor) 2 x screws 2 x wall anchors
Alarm
indicator
Probe
Holder
Probe cable
port
1. Peel off the cover from the back of the holder to reveal the adhesive tape
and screw hole. Place one screw through the front and mount it
accordingly.
Setup
2. Click the water sensor onto the holder. Line up the probe cable port with
the indented flange on the bottom of the water sensor.
Page 2
3. Plug the probe cable into the cable port.
4. Test the water sensor by placing the probe in a small puddle of water. If
the water sensor has been installed correctly, it will beep when it
touches water.
Page 3
Minimum requirements:
• Smartphone or tablet running iOS 9.0 or later / Android 5.0 or later.
• 2.4 GHz WiFi Network (not compatible with 5 GHz connections).
• Upload speed of at least 2 Mbps.
1. Download the App by scanning the QR code or by searching
"Wasserstein App" in Google Play Store or the App Store.
2. Sign up for a new account or Login to an existing account.
3. Click "Add Device" or "+" in the top right corner. Then, select "Add
Manually" or "Auto Scan".
Page 4
App Setup
1. 2.
3. 4.
Page 5
To use Auto Scan, please enable Bluetooth on your mobile device.
Page 6
Use the App to control the settings of your Smart Water Sensor, including
the alarm and low battery mode, as well as view your device record.
1. Open up the water sensor and remove the battery.
Resetting the Device
2. Put the battery back in. Press and hold the button until the light starts
blinking.
Page 7
CR123A - 3V
80 -110 mA
27.8 uA
2.4 GHz
147.6 ft
2.6 x 2.6 x 0.9 in
2.7 x 2.7 x 1.3 in (with holder)
IEEE 802.11b/11bgn mixed/11bg mixed
Power:
Working Current:
Sleep current:
Wireless type:
Wireless range:
Size:
Supported Wi-Fi
Standard:
Specifications
Get More Support
Made in China
www.wasserstein-home.com
Wasserstein is a trademark of Dropcases Ltd.
Table of contents
