Wasserstein Spotlight Kit for Blink Outdoor and Indoor... User manual

Spotlight Kit for Blink Outdoor
and Indoor Camera
USER MANUAL

In the Box
Page 1
1 x spotlight 1 x rubber casing
1 x USB power cable 1 x split USB
adapter cable

Page 2
How to Install
Note: Fully charge the spotlight before using.
1. Make sure the labels on the back of the spotlight are
right-side-up, and slide the spotlight into the top of the
rubber casing.
2. Make sure the Blink logo on the front and labels on the back of
the Blink Cam are right-side-up, and slide the Blink Cam into
the bottom of the rubber casing.

Page 3
3. Plug the split USB adapter cable into both the spotlight and
Blink Cam USB ports.
4. Plug the USB cable into the split USB adapter cable.

Page 4
5. To adjust the timer, flip the switch on the right side:
30 seconds, 1 minute, or 5 minutes.
4. To turn on/off, flip the switch on the left side. Flip left for ON,
right for AUTO.

Page 5
Specifications
100 lumens
120 degrees
5V 1A
1 x 2.2 x 1.4 in
micro USB
130 -150mA
6.6 -16.4 ft
2mA
2-3 days
8
4000K
-4 °F to 131 °F (-20 °C to 55 °C)
Lumens:
Angle:
Power supply:
Dimension:
Connection:
Operating current:
Motion sensing distance:
Standby current:
Battery life:
Number of LEDs:
Light temperature:
Operating conditions:

Blink Outdoor Camera is not included.
Blink Indoor Camera is not included.
Wasserstein is a trademark of Dropcases Ltd.
Wasserstein is not affiliated with
Immedia Semiconductor, LLC.
Blink is the trademark of Immedia Semiconductor, LLC.
Scan the QR code below or email us at [email protected].
Made in China
www.wasserstein-home.com
Get More Support