Watermark 38-0.1 User manual

Élan Vital
Bath Accessories Installation
Élan Vital – Bath Accessories Installation Guide Page 1
•Use plywood backing in walls whenever possible, to ensure security to wall.
NOTE:
•When installing towel bars, be sure that distance between center of posts is correct before
drilling into wall.
•Do all painting, staining or wall papering before accessory installation.
38-0.1/0.1A/0.1B Towel Bar
1) Determine where you want to install the towel bar.
2) Place towel bar on wall at desired position and ensure that it is level.
3) With a pencil, mark the centers of the mounting hole positions on the Mounting Flange (1).
4) If using the supplied Wall Anchors (3), drill a ¼” hole at each marked position (1 ¾” min. hole
depth).
5) Insert anchors into holes until flush with the wall (a hammer may be needed to lightly tap the
anchors flush).
6) Secure the Towel Bar Assembly (4) to the wall using the supplied Screws (2).
38-0.4 Paper Holder
1) Determine where you want to install the paper holder.
2) Place paper holder on wall at desired position and ensure that it is level.
3) With a pencil, mark the centers of the mounting hole positions on the Mounting Flange (1).
4) If using the supplied Wall Anchors (3), drill a ¼” hole at each marked position (1 ¾” min. hole
depth).
5) Insert anchors into holes until flush with the wall (a hammer may be needed to lightly tap the
anchors flush).
6) Secure the Paper Holder Assembly (4) to the wall using the supplied Screws (2).

Élan Vital
Bath Accessories Installation
Élan Vital – Bath Accessories Installation Guide Page 2
38-0.5 Robe Hook
1) Determine where you want to install the robe hook.
2) Place robe hook on wall at desired position and ensure that it is level.
3) With a pencil, mark the centers of the mounting hole positions on the Mounting Flange (1).
4) If using the supplied Wall Anchors (3), drill a ¼” hole at each marked position (1 ¾” min. hole
depth).
5) Insert anchors into holes until flush with the wall (a hammer may be needed to lightly tap the
anchors flush).
6) Secure the Robe Hook Assembly (4) to the wall using the supplied Screws (2).
For technical support or warranty information, please call 718-257-2800
IMPORTANT INSTALLATION INFORMATION
•DO NOT USE PLUMBER’S PUTTY ON ANY OF THE BRASS COMPONENTS
-This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone
is recommended.
To help ensure the beauty of brass accessories, never install an item until construction is almost
completed and after:
•Workmen have finished treating nearby tile or marble with acid or chemicals.
•The air conditioning or heat has been turned on.
•The room has been painted or stained.