WaterRower S4 Quick start guide

S3 TO S4 MONITOR UPGRADE
1
Remove the handle from the handle rests and place the handle in the full forward
position.
2
Stand the WaterRower upright and disconnect the bungee.
Lay the WaterRower down.
Remove the tie rods and JCB bolts connecting the top deck to the tank assembly.
JCB Bolts Upper Tie Rods
*Barrel
Nut

3
Remove the top deck assembly, being careful not to dislodge the guide pulleys.
You will need to disconnect the tacho pulley and the tacho motor plug.
Remove the Tacho Pulley from the clutch.
4
Unfasten the S3 Monitor Retaining Pin & remove the monitor from the key bracket.
5
Place the S4 monitor sensor disk onto the clutch. The internal boss ts around the
internal boss of the clutch.
pr

6
Position the S4 monitor assembly through the right key bracket as shown.
Ensure that the spring and washer orientation is correct. Replace the R Pin retaining
the monitor assembly as shown. Place the new S4 Top Deck, top side down, on the
top of the tank on the side opposite the monitor.
Connect the sensor connector.
OK
WaterR ow er SeriesIV Perf ormanc eMon itor
workout
programs
stored
programs
zones
ho ld /reset
unitsadvanced
on
7
Place the new S4 top deck on the tank, making sure to connect the sensor.
8
Replace the JCB bolts and tie rods connecting the top deck to the tank assembly.
Ensure that the tie rod cross dowel slots are aligned with the tie rod. You may utilize
a screw driver to assist this.
JCB Bolts Upper Tie Rods
*Barrel
Nut

9
Stand the WaterRower upright and connect the recoil belt to the bungee.
Note: If the recoil belt buckle and D-ring have been removed it will be necessary to
ret them before Step 9 may be completed. Refer to the Recoil Buckle Replacement
instructions at www.waterrowerservice.com for details.
If you have any questions, please contact one of our customer service
representatives. Visit waterrowerservice.com/contact-us for information on your
nearest WaterRower oce. Exploded artwork, videos and other instructions are
available at: www.waterrowerservice.com
WRM7016