Waterworks CNMR01 Instruction sheet

INSTALLATION GUIDELINES
PAGE 1OF 2| UPDATED ON 2.24.2023
PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM
STYLE No. CNMR01
Henry Chronos Wall Mounted Large Rectangular Mirror
37 5/16” x 20” x 1“
TECHNICAL DETAILS:
DETAIL
SPECIFICATION
PRIMARY MATERIAL
Brass
WEIGHT
22lbs [10KG]
IMPORTANT:
➢To ensure this product is installed properly, you must read and follow these guidelines.
➢The owner/user of this product must keep this information for future reference.
➢Install adequate blocking or position over a stud to properly secure the fixture.
➢Inspect this product, upon receiving, to ensure it is the correct model and you have all
parts required for proper installation.
➢This product must be installed by a professional licensed contractor. Be sure your
installation conforms to all federal, state, and local codes.
➢Take all necessary precautions to ensure that this product is protected during
installation.
➢Before drilling the wall check for electric cables and pipes. Never drill above or below
light switches or plug sockets.
Parts Included:
A. 1x Main Mirror Assembly
B. 1x Wall Hanger
C. 4 x No. 8 2” Wall Screws
D. 4 x Red Wall Anchors
508mm [20”]
948mm
[37. 5/16”]
25mm
[1”]

PAGE 2OF 2| UPDATED ON 2.24.2023
PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM
INSTALLATION GUIDELINES
STYLE No. CNMR01
Henry Chronos Wall Mounted Large Rectangular Mirror
37 5/16” x 20” x 1“
Method of Installation
1. Using a tape measure, check the location where the mirror is to be installed. Be sure the
mirror will fit in the desired location.
2. Place a soft surface like a towel underneath the working area to avoid damage to
surfaces.
3. Mark with a pencil where the very top and center of the mirror need to be located.
4. From the top of the Mirror, measure down 1 ½” and mark this spot for the height of the
of the Wall Hanger holes. (Fig 1)
5. Place the bottom of the Wall Hanger on the wall and using a level to check that it is
horizontal then mark the screw locations though the holes.
6. Using a drill and 7/32” drill bit, pre-drill the holes for the wall anchors. Lightly tap the
wall anchors into place with a hammer.
7. Reposition the Wall Hanger secure with the screws provided. Check the level again to
determine that it is straight and horizontal.
8. Carefully place the mirror onto the installed Wall Hanger. The mirror can then be
adjusted side to side by gently sliding the mirror along the wall hanger to ensure the
mirror is centered.
Fig 1
Tools needed:
Pencil, tape measure, spirit level and screwdriver or a standard drill.
Please note the below instructions and fixings provided are for a masonry wall. If you are
installing to a plasterboard wall, partition, or any other wall, we recommend a timber battens or
frame behind the wall for support as well as source any special screws or fixings needed.
38mm
[1/2”]
Wall Hanger