you are connected to, to see your current
network status.
Connect the Rogue’s POE adapter
using a router make sure that your laptop or tablet
is connected to the router that the
Rogue is
address from the Rogue (a Windows computer will
generally show the message icon “Connected” at
192.168.89.1 ” into the address bar and press
“enter”. The Network Scan page will then open.
Depending on the device you are using to manage
the Rogue unit; the page look similar to this.
networks (HotSpots) is ordered by signal strength:
the strongest signals are indicated by the color
GREEN. You will also see ORANGE or RED for
signal changes around you. To connect to a
will be a drop down once you click on the network
During this process the screen will show “ Three
See “Quick Tips”
When using a coupler make sure that is can be used for POE.
again. This should last 30 secs and should be the Rogue as well as the
router it is connected to.
Check the lights on the POE injector. They should both show solid green.
the ethernet port tabs are not damaged).
Copyright Wave WIFI Inc., 2017. All rights reserved.
Follow Us!
AVE
WiFi
On the Water and Online
page. “Disabling EC Firewall” removes your
users. However, it may be necessary to disable
this feature to access some HotSpots. Clicking
“reboot” disconnects the Rogue from the
current hotspot and also refreshes the
reboot if the hotspot is not a favorited
1.) Connect to the network that you want to favorite.
Rogue Reach Family Quick Start Guide
Page 2
