WBC NORWOOD RN61 User manual

Wooden 3 Tier Stand 650mm - ref:RN61
Assembly Instructions
Estimated Assembly Time: 15 minutes
NORWOOD
COLLECTION

Components
Recommended
Whilst a hex bolt key is
provided it is far easier to
assemble using an electric
drill or screwdriver with a
4mm hex tting.
cRNL61 x 2 cRNS61 x 6
x24
x1

1. Attach the 6 shelves to one of the tall uprights using the screws provided. Do not fully
tighten. There are 3 reversible front shelves with a front bar on one side and a middle
bar on the reverse. The front bar should be facing upwards for kits RN61G, RN61J,
RN61M and RN61W. For kit RN6WI the middle bar side should be facing upwards
2. Now attach the second tall upright. Again, do not fully tighten the screws.
Middle bar
Upward facing bar

3.
4.
Move the assembled frame into position in your store and then tighten all the
screws. This will allow the unit to sit more squarely on slightly uneven oors.
If the optional chalkboard was purchased, please simply slide the board
into the two slots located at the back.